Got my water injection hooked up, heres a few pictures: 01 Audi TT 225 - Ko4 Pump located behind the driver headlight, chopped up my airbox to fit...

Getting close to getting stage 2 (dual nozzle) snow kit installed. I started threading the nozzles into my BSH throttle pipe and the throttle pipe...

Im heavily researching W/M prior to purchasing a kit, and I have settled on the DO stage 2 kit. Now, I am just trying to understand the best...

Have an 06 Audi A3 and I'm trying to find out where to get ignition power source for the controller. Most diy's don't get very detailed on that part...

I have a few different questions and would like some peoples personal oppinions or information. I am new to the water methanol scene. Ive heard...

I have a 2007 passat with the FSI motor. Looking at getting a Devils own stage 2 progressive kit. Will be running 50/50 , I have the fully loaded...

I know this is probably a silly thread to start, but I'm going through a bt build that is pretty extensive as it includes a 2.0L stroker build,...

I have a 2000 VW Beatle 2.0. The water hose that connects to the water pump and to some other part of the engine has broken at the connection. Can...

So I finally have my Snow Performance water/meth system installed, running 1 nozzle in USRT TB spacer and 1 post IC. I have started at setting...

How many of you are running a 100 octane file with water and meth?....I'm on a 50/50 mix of distilled water and pure methanol....i spoke with Thomas...

This forum is dead so i figured i'd might as well post up some of my w/m setup. I'm using a CoolingMist Stage 3+ CM 200psi pump CM VCM2...

Found my local AutoZone carries this. $3.99 a gallon. According to the MSDS, it's 30-60% meth, the rest water, with a little bit of ethylene. Anyone...

looking into water/meth for my 04 2.0 Passat TDI. Additional power is secondary to MPG as far as what I'm after. What unit do you have? How...

Hey there! I have a built 1.8t with a gt3076 and a buddy of mine just gave me his snow performance w/m kit but I don't know what nozzle it has. So I...

Mine just lights up blue and the company when under so If some one out their has one I will buy it :thumbup:

I hear there is a ECM problem where a hot start is concerned, but they say the new ECM tune will not fix my cold start problem. Everything checks...

So I been looking into running my W/M through my injecots that I have. I run 4 extra on my car so I was wondering if this could be done, I use a sds...

Running into packaging restraints because I want to keep a/c so just wondering if I shrink the IC would having WMI be able to compensate for that? ...

http://www.horsepowerfreaks.com/images/products/HPF/Stage3.gif HPF Stage 3 M3 with 71mm turbo.

Any advice?

I got my kit used so it didn't have the hose. I bought some clear tubing at home Depot but found a crack in it the other day. I can't tell if the...

I posed this to the G60 forum, but i figured i might get a good response here too So lately I've been doing a lot of research and reading up on...

I'm about to purchase the snow performance stage2 for my 2.0TFSI, but since i compared with the other brand most of them hav the reverse check valve...

Hello. I recently replaced the throttle body in my 2001 Jetta Wolfsburg 1.8T. Now, about three months later, I am getting some of the same erratic...

ok i have a 2010 vw gti, and i just bought the snow performance stage 2 maf kit. i have it all wired up correct and even confirmed it with josh from...

Hey fellas, I have a MKV R32 and plan to install a supercharger kit in the near future. I'm not planning an "all out" build by any means - only in...

I was driving other day when I got a traction light and flashing epc light on my cluster. Things went downhill quickly from there. Throttle body...

I searched and searched but can't find any useful info like logs, dynos, results, playing with timing... I fully pushed my 1.8T with W/M and knows...

hey guys well i purchased a snow performance kit from a guy locally here in Namibia, but i wasnt informed that it gets its signal from the MAF, am...

Has anyone used a devils own DVC30 controller using voltage rather than the boost input to control the unit? I purchased one a while back and it...