http://images.ecwid.com/images/1275003/44967265.jpg SAI delete plates 1.8T motors. -allen head hardware included -Uses factory gasket ...

Shift Bracket Bushings Our billet aluminum bushings were designed to replace the factory rubber bushings that hold the shift linkage bracket to...

So I sold my BT GTI to my good friend, only to find out that he went HALDEX on my ASS !!<p>Big PROPS to Will Papatolevski. Owner and Operator of AST...

Hello everyone, wasn't sure where this should be posted but 1.8t forum made most sense.. I just picked up a b5 a4 1.8t quattro 5 speed, it is an...

What I mean is, how would the OEM do it if they were to build a 400whp 1.8T? Perhaps a 2.0L or 2.1L stroker, headwork, cams, with a smallish turbo...

https://sphotos-b.xx.fbcdn.net/hphotos-ash3/582602_3996729768949_1933303185_n.jpg MJM is ready to launch off this year with the very best in both...

Is it possible for the 2step to bend intake valves? What negative effects does the 2step have on a car?

Which VP race fuel would be equivalent to E85 in the increase over 93pump gas?? In other words which VP fuel would you expect to make the same...

I know I already posted in the maestro thread but the has to be a solution. I'm running 630cc genesis II injectors with Eurodyne. I changed the BVC...

First...this is what I have (sorry, it is dated & a bit braggadocios..but true): 2K MKIV 1.8T, AUTO, BLACK, PURCHASED 07/21/12. MODS: APR STAGE II...

After some spirited driving up west coast of Norway from sea level to 1300meters height my oil cooked and rods broke. The motor was BAM 225 chipped...

http://portland.craigslist.org/mlt/pts/3764986868.html so this guy is selling an F23 turbo and he says that all it will take is the manifold and...

How do I choose the correct bov spring on a mafless bt build that will have big cams? Aka, at what vacuum should the bov begin to open?

So my gates racing belt snapped. This is the reason i bought gates so my t belt wouldnt break, 40 miles after valves were replaced t belt breaks. ...

So ive got an 02 1.8t gti 5 speed The car ran fine and i decided to replace the front suspension components and change the oil. I didnt start/move...

so i ripped this passat 1.8t apart after figuring out how screwed up it had gotten due to coked oil and clogged arteries. the previous owner said he...

Just picked up an 03 gti yesterday and I need to get a catch can set up. Pm me if u have one for sale.

I will update accordingly Top End: IE CVA1 cams AEB Head - stock ports ST Inconel Valves Single Groove ST Springs and Retainers 3-Angle...

It's time to share with you what I do with my car recently ;) Over the past few years, I was happy with my APR stage 3 + (GT 2871 for TT225) but...

I posted this in the GLI forum and all I got was the usual downers, so i figured I would post it over hear. I finally just about have everything...

probably beaten to death topic but quick question.. (and if you have figured it out by now I'm cheap *btw the 6 puck $120 clutch kit still...

Okay so on my way home the clutch pedal went to the floor and was stock in gear, I pulled over turned off then put it in first and started it back up...

Ok, so my girl bought an A4 with a blown turbo. We didn't know it at the time (I'm a subaru guy and it's my first audi) but the previous owner...

I experienced some kind of catastrophic failure today while driving my 2002 1.8T (2.1L + GTX2867R). I have a Clutchmasters FX200 Kevlar clutch mated...

I'm looking at an upgrade from my R1 diverter. My car has since out grown it:laugh:. Not sure what do get yet but these seem like good options. ...

Trying to figure out what is the best dwell time for each type of coil. I've read conflicting reports that the 1.8t stock coil pack can take...

I have a 2004 vw gli, and i was wondering if there is a performance difference between brands... and if i get a custom exhaust done with say 3''...

Recently my car (02 Jetta 1.8T) has been having some hard cold starts. It is starting fine if the engine has been run in the past 5 or so hours but...

What's the normal operating temp after a oil cooler install? I googled it and found a thread on Audizine, and my psi is simular... As far as oil...

Idk if anyone had this problem but I'm on my 3rd Map sensor I keep messing em up when I seem to use no lift and holding boost in between gears. Any...