was thinking of going stand alone... more specific the lugtronic plug and play unfortunatly its my dd so anyone think its possible or will i be...

My car has 185k and I want more power. My options are either, swap a low mi 2.0 in and bolt the NS SC on(all CARB legal of course); or rebuild and...

Hi VW forum. I was wondering if anyone has the answer to my question here. I want to swap a 1.8 engine from a 98 Golf into a 98 Jetta. I was looking...

Hi all, Working on a new project. 99 Mk4 GTI. Been doing some routine maintainance stuff because the car has been sitting for a few years....

just curious.

Hello Everyone! Long time listener first time caller here. I recently purchased a 02 cabrio and did a lot of trouble shooting with the help of the...

My friend has a 2004 2.0L Jetta and the fuel pump has junked out on her... I am not big into the mk4 world, does anyone know what year pumps will fit...

anyone know what year mk4 2.0 came with the aluminum valve cover with the recessed gasket? ive got a frankenmotor in my 98 golf and dont remember the...

... I just got this car off the previous owner with 118,xxx km's on it. I am changing all of the gaskets and seals except the rear main seal and the...

Hi! It all started yesterday. After driving 100km on highway I stopped the car for 30minutes. After that there was horrible smoke from exhaust. It...

I have been looking around and I can not find the answer I am looking for. I have a 2003 2.0 AVH engine that the o2 went out on in turn burned out...

Picked up a mk3 k2 with 2.0 ABA obd2. When i got the car there was a few issues with it i have fixed. Just finished getting car repainted and all...

I have transplanted a 97 ABA into my 70 beetle and having some wiring problems. I have fuel, and my code reader says all sensors (minus O2's) are...

I've tried searching with minimal results. My current problem is that the driver side seatbelt will not retract the belt back in. It is extended...

It only happens when I'm in stop and go traffic or occasionally driving it hard I have plenty of oil and make 120 mile trips every other week with no...

I know that this sounds pretty simple but I am stuck. Okay, so what's my problem you ask? Well, first I am not much of mechanic, but I like trying...

Car Info: 2002 Jetta GL w/5Sp My question: Is this engine an interference type ? Reason for my question is due to a Timing-Belt (TB) slip. The TB...

I bought a 96 Jetta that the PO did a manual trans swap with. I'm trying to get it to pass emissions but the TCM is still wired up and throws trans...

1995 Stock 2.0l Golf 5spd - completely dead electrical system. My friend lives in Rhode Island, I'm in WA state. Can't be there hands on. :) ...

Just found a new Coolant leak under my front valence on the left side, right side when looking at the car from the front. Drain valve is closed and...

Okay, I know theres a million threads about 02 wires here, but none pertain to my situation. I have a '94 Golf GTi, and the 02 sensor harness wires...

alright, im at a loss for words. ive spent 2 weeks diagnosing this issue and searched everywhere for answers. my maf sensor is not getting power. ive...

... are they all the same seal? I only ask because nobody seems to be able to find me the intermediate shaft seal. I am looking at the cam and crank...

SOLVED!!!!!! Almost calling it a bad ecu at this point. Car ran fine 2 days ago, a quick spray of the engine bay and now it won't start...

A have a few questions here. I swapped in a mk4 intake manifold on my ABA and I'm experiencing some stalling issues. I happens as the revs fall,...

Last night car started to vibrate from left front tire. not quite sure why but only vibrates under acceleration please help before dustoff.

I have been driving the car for a few months and its been overheating, but i dont have to drive very far so i let it go, now for some reason after 5...

When installing the thermostat does the gasket go first or does the gasket go on top of the thermostat?

I have a 2004 jetta with the bbw engine. Can i swap another cylinder head onto a bbw engine without major modifications? If so, which will fit...

i bought a short block with rods/pistons, crank, and all the caps, $50 i disassembled the block and i found some wear on the block and the crank...