Montronic ECU stock chip and C2 stage 2 chip $300 obo Harness $100 034 Crank trigger wheel and Bracket $50 BBM 3 in mass air flow housing and...

I've run into a wiring issue with my fan harness and engine harness. I have a 3 pin plug and 2 pin plug on my fan harness that does not match up...

1990 Vw Corrado G60 200k miles. The cooling fan is not turning on until 220 degrees Farenheight. I changed a new low speed relay, new radiator fan...

Today i installed a TT cam in my car installed BBM Stage 4 Chip i already have kpa map sensor 30lbs injectors and 62mm pulley car ran pig lean...

Got myself an ABA block (iceman666) and will be running this with a G60 head and a G-Lader. I was trying to figure out every part i need and what i...

<br>*FIXED*FIXED*FIXED*FIXED*FIXED*FIXED*FIXED*FIXED*FIXED*<br> <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/biggrinsanta.gif"...

Anyone have a pic of this installed? I'm trying to figure out how to connect the lines over by the FPR. On the stock rail, there's a line that...

Hi.. first of i can tell you that i'm not new to the G60 ecu (DF1). and know how they work, but this issue has me by my balls. and i can't figure...

So besides BBM IS dave at KK still MIA?

does anyone have one installed? How was the fit and looks? and any power gains?

I thought I would stir this topic up a bit... time to bring this back for the 8v guys thinking about real performance :) First of all I want to...

Hello guys, I have noticed that when i turn my ignition to the on position, my fuel pump primes, but it does it for like 30 seconds. I remember...

Can anyone confirm If it is OK to use the stock G60 "Victor Reinz" head gasket with a PG motor bored to 82mm? I have searched and found some say...

like to hear your thoughts on this. I have my co set to 435 ohms but with wideband and cts sensor unplugged my a/f is at 10.7 last year I...

Greeting, vw lovers! This is my first post, and I would like to represent you my Passat 35i Syncro powered by PG and toyota supercharger. ...

I purchased an engine that is suppose to have JE pistons in it. Is there a way to verify this without taking the head off? Like from underneath?...

Been wanting to pull the ECU for a while now to see if it had a chip in it. The car is quick and I had a feeling it might. A past owner spent the...

So the story goes as me having a G60 Corrado. When I bought the car I was unsure on the condition of the charger, sure enough it was on its way out....

I've been doing some research for a rebuild I'm doing and have put together A LOT of info I've found useful and figured I'd share it. Here's a...