There is a clicking sound coming from the engine only when the car is in gear. The timing chains have been replaced already but this sound is a new...

Flashing CEL for a few seconds then it went pulled out the manual and it says clogged converter when this happens. So my question for everyone is...

Picked up a Eurovan that was diagnosed with needing a timing chain replaced. Wouldn't idle, cam position codes (that didn't move with the sensors)....

got jealous of the 1.8t technical section and had free time and i figured id try to compile a lot of the info thats floating around here. tried my...

:o I had the engine (AYL) rebuld after this ...

I have codes p0600 and p0016. Just started my car and it sounds like a knock when I start it and when I shift using the clutch or sometimes without,...

I have a 2001 VR6 Jetta that I parked at work and when I came out it would turn over but wouldn't start. The next day I tried to start it and it...

Thought I'd throw some pictures up here since many of you don't venture into the Mk. IV forum. :wave: If you've got any questions or comments,...

http://i226.photobucket.com/albums/dd25/issamabed/INAEngineeringLogo-NEW.jpg *** 2.8 12V | 2.8 / 3.2 24V | 3.6 24V VR6 - FLUIDAMPR Pulley *** ...

So I am on a quest to bring the over all temps down in my engine. I have been researching oil coolers and have pretty much made up my mind on a Mocal...

Hopefully an easy to answer question - is it possible to have immobilizer, ESP, etc removed from a 24v ECU? Also, is it possible to rewrite software...

So I have a mk3 gti 24v vr6, I wired it up with my original 12v vr6 harness and ecu. I Know the 12v ecu do not carry the option for vvt so I wired in...

Long story short I've got a spun rod bearing in my Eurovan 2.8l 24v VR6.The motor itself was very caked with crud inside when I got it and might not...

APR is pleased to announce our product line from ECU upgrades to Stage 3+ Turbocharger Systems is on sale! March 25th through April 28th ...