VWVortex


+ Post New Thread
Page 2 of 4 FirstFirst 1 2 3 4 LastLast
Threads 31 to 60 of 113

Forum: 8v Engine Forum

  1. 8v to 16v Conversion

    Well I found 3 cracks in my 8v head I wanted to build so I am in need of a new head and I was thinking about upgrading to a 16v head. I have been...

    Started by tomlinja26, 04-25-2013 09:00 PM
    • Replies: 6
    • Views: 428
    05-08-2013 07:59 PM Go to last post
  2. Fox Engine into Vanagon

    Hey, folks! I'm thinking of swapping an I4 into my Vanagon using the stock diesel 50 degree stuff. I will run it on the digifant ecu and afm I...

    Started by nemobuscaptain, 04-23-2013 12:25 AM
    • Replies: 3
    • Views: 275
    05-08-2013 02:07 PM Go to last post
  3. Camshaft wear?

    Hey guys. Quick question, I got my valve cover off to replace the gasket. What are some signs of wear I can look out for in the cam? There don't seem...

    Started by SuperchargedA4, 05-07-2013 07:02 PM
    • Replies: 4
    • Views: 167
    05-08-2013 01:14 PM Go to last post
  4. What's classed as a 'high compression motor'

    Compression tested the 1.8 8v I have, all cylinders showing above 150psi. Is that referred to as 'high'? Twin 40 weber 288 cam P+P Head...

    Started by Keif, 05-03-2013 11:41 AM
    • Replies: 2
    • Views: 247
    05-08-2013 03:06 AM Go to last post
  5. 3 coolant temp sensors?

    i have a white 1990 jetta gl running digifant I. Connected to the front of the head is a housing containing a black temp sensor and a blue one....

    Started by anthonyleehamilton, 02-23-2013 08:26 PM
    • Replies: 7
    • Views: 452
    05-08-2013 03:02 AM Go to last post
  6. Euro 8v 1.8l CIS

    Hello forum. I'm the proud owner of a Eurospec 86 Scirocco w/ Euro 8v 1.8l CIS/5spd swapped in from a MK2 GTI. It is cammed w/ 4-1 header. I'm...

    Started by mrwarrenpiece, 05-06-2013 05:08 PM
    • Replies: 2
    • Views: 160
    05-06-2013 06:05 PM Go to last post
  7. Parting out my build

    Montronic ECU stock chip and C2 stage 2 chip $300 obo Harness $100 034 Crank trigger wheel and Bracket $50 BBM 3 in mass air flow housing and...

    Started by G60Jetta1990, 05-06-2013 09:39 AM
    • Replies: 1
    • Views: 144
    05-06-2013 05:51 PM Go to last post
  8. 8v cold start/idle issues

    hey Guys. So im new to the 8v world, im a vr6 guy usually. however i came across a good deal while in the market for a clean mk2 to put my vr...

    Started by Bandwidth, 04-23-2013 11:30 PM
    • Replies: 4
    • Views: 298
    05-06-2013 05:41 PM Go to last post
  9. Valve Guides - need advice

    I have new valve guides to put in my JH head, and I am perplexed about getting them in safely. I got the old guides out with a little banging, but...

    Started by Romeo Chi, 04-22-2013 05:53 PM
    • Replies: 3
    • Views: 241
    05-06-2013 11:23 AM Go to last post
  10. aba 8.v hydraulic timing belt actuator question

    Hello all im in the process of replacing my timing belt, tensioner , and water pump. I replaced the water pump , belt and tenisoner no problem, my...

    Started by absolutky, 05-03-2013 09:04 PM
    • Replies: 3
    • Views: 188
    05-05-2013 10:20 PM Go to last post
  11. aba knock sensors

    I have my block torn all the way down, and need to know which bosses are for knock sensors so I don't make mounts and use those bosses. thanks ...

    Started by my2000APB, 05-04-2013 11:17 AM
    • Replies: 1
    • Views: 134
    05-04-2013 03:11 PM Go to last post
  12. 84 8v Scirocco hesitation then quit running

    So, my Scirocco has a hesitation when upshifting. Violent bucking while accelerating which can be eased by feathering the gas. I was used to the...

    Started by 5xScirocco, 05-03-2013 12:41 AM
    • Replies: 2
    • Views: 144
    05-04-2013 12:47 AM Go to last post
  13. Porting the 8v head.....

    I know this has been asked a million times....and ive been reading about 2 hrs every night in the search forums about this topic....But does anyone...

    Started by TheMajic86GTI, 10-30-2009 09:22 PM
    7 Pages
    1 2 3 4 5 ... 7
    • Replies: 219
    • Views: 79,034
    05-02-2013 02:49 PM Go to last post
  14. Eurospec 8v head rollcall... post if you have one thx...

    Hi Folks,<p>Have/running a Eurospec head? Post up please!<p>best regards,<br>Peter T.<p>Current List of Eurospec Head...

    Started by Peter Tong, 12-20-2006 07:02 PM
    5 Pages
    1 2 3 4 5
    • Replies: 170
    • Views: 23,372
    05-02-2013 01:58 AM Go to last post
  15. 2E engine turbo on stock internals ???????

    i if wannaaa go turbo on my 2E engine but with stock internals is it will go damage or will be ok i will make 4 or 5 psi

    Started by a1aa1992, 04-21-2013 09:12 PM
    • Replies: 4
    • Views: 326
    05-01-2013 09:11 PM Go to last post
  16. ABT camshaft?

    Hey guys I was pulling some parts at my local yard and found a camshaft that was stamped ABT, as well as bearing the vw and audi logos and the letter...

    Started by mk1_luv, 04-14-2013 09:09 PM
    • Replies: 7
    • Views: 370
    04-30-2013 10:44 PM Go to last post
  17. MK2 GTI 5-speed removal question

    Hello everyone, I'm installing a clutch in my 85 GTI but unlike my Sciroccos the transmission does not clear the subframe when the engine is...

    Started by r1cw, 04-28-2013 05:15 PM
    • Replies: 4
    • Views: 197
    04-29-2013 01:16 AM Go to last post
  18. Vibration when turning right after alignment

    So a few months ago I picked up a mk2 gti as a beater and I love it so far Since I got it I have replaced: Both front axles with new axles due to...

    Started by jakellama123, 04-25-2013 12:47 AM
    • Replies: 4
    • Views: 289
    04-29-2013 12:54 AM Go to last post
  19. 8v mild head build :)

    So I started a mild and first time build over this last summer. I am 18 years old and just wanted a bit more pep out of my 2.sl0w I will post...

    Started by jkem21cb, 12-17-2012 11:04 PM
    • Replies: 7
    • Views: 1,102
    04-27-2013 09:14 PM Go to last post
  20. upgrade the 2.0 2E engine preformance (take an idea & give advice)

    i have 2.0 2E engine 8v in my audi 80 1974 so i have light flywheel and i have removed the power steering pump i found on google that gave the engine...

    Started by a1aa1992, 04-26-2013 08:15 PM
    • Replies: 3
    • Views: 258
    04-27-2013 08:31 PM Go to last post
  21. Installed my ebay header, my thoughts on it

    Well, I just finished installing my ebay header, you know the S.S. one that looks like this:...

    Started by ps2375, 04-02-2013 03:32 PM
    • Replies: 7
    • Views: 615
    04-26-2013 11:35 PM Go to last post
  22. Turbo build - street car

    Let me start of by saying I'm not new to turbo'd vehicles but it is my first time matching everything up and starting from scratch. I have a 97 Jetta...

    Started by Fabriccio, 04-25-2013 01:01 PM
    • Replies: 1
    • Views: 224
    04-25-2013 09:19 PM Go to last post
  23. help 2.0 8v aeg turbo oil feed line

    I need help im building a 2.0 turbo but need help with the oil feed line where do i install it?? My oil pan has the oil return line but not the feed...

    Started by iwy90, 04-23-2013 09:19 PM
    • Replies: 1
    • Views: 206
    04-24-2013 10:11 PM Go to last post
  24. 8v knock sensor help please!!!

    I just replaced the tranny on my 85 GTI, also replaced the distributor because the Hall Sender was damaged. started it up and it would misfire crazy...

    Started by Roman5400, 04-24-2013 01:35 PM
    • Replies: 0
    • Views: 157
    04-24-2013 01:35 PM Go to last post
  25. More 8v Oil Light Questions

    I have read alot on here about the oil light on the mk1's but it seems like my issue is fairly unique. My oil light is ALWAYs on from the second i...

    Started by VWunion Chad, 04-15-2013 03:58 PM
    • Replies: 9
    • Views: 360
    04-24-2013 01:33 PM Go to last post
  26. GT25R powered 1.8l 8v counterflow 24 Hours of Lemons build narrative

    So I wanted to start a build thread for a car I hope to field in the 24 Hours of LeMons 2013 season. For those unfamiliar, the 24 Hours of LeMons...

    Started by derekste, 11-20-2012 12:41 PM
    • Replies: 10
    • Views: 2,215
    04-24-2013 12:21 PM Go to last post
  27. g60 cam on 2E engine it will be better or not

    i swaped a 2E engine in my audi 80 1974 and i wannaa upgrade its preformance i think about the g60 cam can it make more power in my engine or not...

    Started by a1aa1992, 04-19-2013 10:07 PM
    • Replies: 8
    • Views: 331
    04-23-2013 11:49 AM Go to last post
  28. 8v 1980 scirocco: my questions along the way

    Picked up a 1980 Scirocco a few months ago and about a month ago i started to get it road worthy again. Did a timing belt job, replaced cam...

    Started by j.fopps, 12-16-2012 10:44 PM
    • Replies: 12
    • Views: 725
    04-23-2013 06:56 AM Go to last post
  29. 84 Scirocco what Injectors

    I have an 84 Scirocco 1.8 8 valve. The car has been heavily worked on (even scavenged from) prior to & during my ownership. When I got her she was...

    Started by Neilyrocco, 04-23-2013 04:00 AM
    • Replies: 0
    • Views: 184
    04-23-2013 04:00 AM Go to last post
  30. 1992 mexican golf strange issue

    Golf gl with 204,000 miles, Digifant fuel management system, mexican built (yeah Im just as amazed its made it this far as you are) has developed a...

    Started by srgtlord, 03-31-2013 11:02 PM
    • Replies: 11
    • Views: 470
    04-22-2013 02:33 PM Go to last post

+ Post New Thread
Page 2 of 4 FirstFirst 1 2 3 4 LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts