VWVortex


+ Post New Thread
Page 3 of 4 FirstFirst 1 2 3 4 LastLast
Threads 61 to 90 of 112

Forum: 8v Engine Forum

  1. ABA Jetta with manual trans swap wiring question

    I bought a 96 Jetta that the PO did a manual trans swap with. I'm trying to get it to pass emissions but the TCM is still wired up and throws trans...

    Started by twoteks, 04-16-2013 11:13 PM
    • Replies: 3
    • Views: 212
    04-19-2013 06:37 PM Go to last post
  2. stupid lower injector holder plastic broke.. how to get it out?

    i saw a trick at one point.. but cant seem to find it.. something about using an eyelet or something to pull the plastic lower injector out. for...

    Started by tinygiant, 04-18-2013 12:52 PM
    • Replies: 2
    • Views: 165
    04-18-2013 08:30 PM Go to last post
  3. Distributor Interchangeability

    I have a 1982 VW Caddy with 1.7L motor. Apparently after numerous volt meter test, it seems that the Hall Sensor is out of service. I need to...

    Started by ffgb, 04-18-2013 01:08 PM
    • Replies: 1
    • Views: 182
    04-18-2013 04:03 PM Go to last post
  4. Digifant II - setting the air/fuel mixture using a wide band?

    I'm working my way through setting up the 91 Jetta engine installed in my 1980 Scirocco (yes, you read that right) by using this write up: ...

    Started by mullantf, 04-14-2013 05:18 PM
    • Replies: 2
    • Views: 246
    04-17-2013 10:07 AM Go to last post
  5. Building 8v Digi2 to 135HP

    Assuming you are starting with a completely stock 1.8L 8v running digi2, what is the most reliable path to getting it to about 135 to 145HP range...

    Started by rallyplasma, 04-15-2013 09:41 AM
    • Replies: 5
    • Views: 342
    04-16-2013 02:24 PM Go to last post
  6. M Grind cam

    I have a mk2 jetta 1.8 8v, I'm looking at the M grind cam TT sells. I can't find much on the cam on the vortex. I know the duration and such but I...

    Started by gir89, 04-08-2013 04:10 AM
    • Replies: 2
    • Views: 292
    04-15-2013 03:22 AM Go to last post
  7. possible?

    Will a 1.8 8v from a 91 jetta drop right into a cabriolet and coordinate with all the existing electronics ? I'm assuming the cabriolet would have to...

    Started by 95VReihenmotor, 04-14-2013 01:38 PM
    • Replies: 0
    • Views: 159
    04-14-2013 01:38 PM Go to last post
  8. '84 Jetta starts stalls

    '84 Jetta, 1.7 5spd, starts and engine races up then quits. Fuel pump is running, relay seems to be fine, if you hold on to it you can feel that it...

    Started by mech644, 04-13-2013 05:50 PM
    • Replies: 1
    • Views: 224
    04-14-2013 12:39 PM Go to last post
  9. 1990 jetta won't start after changing head gasket...

    So my jetta recently blew a headgasket, it would still start of course but ran like ****. So i changed the head gasket and now that I've gotten...

    Started by anthonyleehamilton, 04-03-2013 07:56 PM
    • Replies: 3
    • Views: 369
    04-14-2013 11:39 AM Go to last post
  10. High Idle w/ 1992 1.8 8V Digi . . . .

    :confused::mad::confused:Just went with a 268 cam install as well as lifters, valves, springs, billet adj cam pulley, Sachs StageII clutch and lt.wt....

    Started by grndoldmanusmc, 04-13-2013 11:58 PM
    • Replies: 1
    • Views: 181
    04-14-2013 11:37 AM Go to last post
  11. rare turbo setup for 8v mk2. need help!

    ok so i have a rare BLT turbo kit that i got from josh at nothing leaves stock. i have a digi 2 jetta that it will be going into. he said the kit was...

    Started by MKIII98Dub, 04-08-2013 11:01 PM
    • Replies: 5
    • Views: 455
    04-14-2013 12:10 AM Go to last post
  12. 1.8 to 2.0 bore question

    Hi am planning to bore my 1.8 DX engine to 2.0, and wonder if I can take the crank, con rod and piston from an 9A engine??

    Started by britishrocco, 04-01-2013 02:33 PM
    • Replies: 3
    • Views: 300
    04-11-2013 10:54 AM Go to last post
  13. Magnaflow converter O2 sensor fit problem

    Has anyone installed the direct-fit Magnaflow hi-flow catalytic converter for a dual downpipe setup on a Mk2? I just put one on, and the oxygen...

    Started by niotaboy, 04-10-2013 11:01 PM
    • Replies: 0
    • Views: 222
    04-10-2013 11:01 PM Go to last post
  14. Hall distributor swap

    Basically I have the points distributor on my 8v and found a hall distributor in good condition at the junkyard. I'm just wondering if this could be...

    Started by mk1_luv, 04-08-2013 04:55 PM
    • Replies: 4
    • Views: 250
    04-10-2013 04:33 PM Go to last post
  15. 1990 jetta no starting(now sounds like miss firing)

    http://forums.vwvortex.com/showthread.php?5950703-1990-jetta-not-starting It looks to me that I am getting a low spark from the spark plug if that...

    Started by speeddownzone, 02-09-2013 07:32 PM
    • Replies: 2
    • Views: 339
    04-10-2013 01:26 PM Go to last post
  16. 8v CIS with upgraded cam revs slower in higher gears

    I have an 88 cabriolet (jh head, CIS, header&exhaust, upgraded valve springs, TT 268 cam, neuspeed TB) which i upgraded from the stock cam last year....

    Started by retsaot, 04-10-2013 08:49 AM
    • Replies: 0
    • Views: 190
    04-10-2013 08:49 AM Go to last post
  17. 8v digijunk2 hot start/idle issues

    I'm working on a 91 golf with a 1.8/8v/digifant2 setup and I'm having issues with hot starts, and idle speed when its warmed up. When the car is...

    Started by d_farm, 12-10-2010 12:40 AM
    • Replies: 3
    • Views: 608
    04-09-2013 08:19 PM Go to last post
  18. Camshaft for 1.8 8v, carbureted.

    I have a 1997 Volkswagen golf with a 1.8L, 8v carbureted engine. I've been searching for a while for a street camshaft for my golf and can not seem...

    Started by dasautovdub420, 10-10-2012 09:23 PM
    • Replies: 20
    • Views: 1,602
    04-09-2013 06:26 PM Go to last post
  19. Ignition test???

    While driving my 82 1.7L, the engine died? The motor cranks but will not fire up. I can hear the fuel pump priming I think? How do you test the...

    Started by ffgb, 04-09-2013 12:02 AM
    • Replies: 2
    • Views: 216
    04-09-2013 12:49 AM Go to last post
  20. oil light uhhhhhh ohhhhhh

    Just a quick question to everyone. I have a 91 jetta with a 1.8 motor. Now my problem has just showed up. Recently changed oil, now when my car gets...

    Started by rub@dubdub00, 04-05-2013 11:17 PM
    • Replies: 4
    • Views: 270
    04-09-2013 12:13 AM Go to last post
  21. post pics of your fav lightweight pulleys

    looking to get some ideas

    Started by xet33, 04-07-2013 12:12 PM
    • Replies: 1
    • Views: 211
    04-09-2013 12:01 AM Go to last post
  22. aftermarket tune?

    if a 1.8 is bored .050 over and has a mild cam like a 268, can that run on a stock tune or does it need a performance chip? if so, what should i be...

    Started by 95VReihenmotor, 04-04-2013 10:47 PM
    • Replies: 4
    • Views: 285
    04-07-2013 10:30 PM Go to last post
  23. Oil light flashing/buzzing 91 Jetta oil light only

    Hi I just picked up a 91 Jetta 1.8 8v It runs ok but the oil light always flashes. I found the oil pressure switch on the head and the one above the...

    Started by towinghondas, 02-08-2009 06:50 PM
    • Replies: 17
    • Views: 1,174
    04-05-2013 11:10 PM Go to last post
  24. Starting problems - Help?

    So my 1990 jetta GL recently blew a headgasket, it would still start of course but ran like ****. So i changed the head gasket and now that I've...

    Started by anthonyleehamilton, 04-04-2013 05:20 PM
    • Replies: 1
    • Views: 185
    04-05-2013 08:57 AM Go to last post
  25. Poll: brainstorming new project carbs, or turbo on mk2 1.8l 8v?

    What do you think? If I go carbs on a mk2 8v i'll probably use a diesel transmission for the gearing. :) If turbo, the standard transmission.

    Started by thollandvw, 04-04-2013 10:38 PM
    • Replies: 0
    • Views: 163
    04-04-2013 10:38 PM Go to last post
  26. Camshaft question

    Is it possible to determine what kind of cam I have in my engine (specifically lift & duration)by measuring the cam lobes? The P.O. told me the cam...

    Started by junkyardjockey, 12-30-2011 01:04 PM
    • Replies: 7
    • Views: 918
    04-04-2013 09:24 PM Go to last post
  27. 8v Misfire???

    I have an 89 Jetta gl 8v. The car runs fine and starts fine. after driving for a few minutes though it starts to misfire and shake. the only solution...

    Started by $$91GTI30L, 01-29-2013 08:58 PM
    • Replies: 6
    • Views: 572
    04-04-2013 10:01 AM Go to last post
  28. Vacuum Lines Question

    Recently got a 91 Jetta GL, and read it was recommended to check all the vacuum lines, i've tried looking for a post/DIY with working pictures and...

    Started by invader253, 04-02-2013 08:30 PM
    • Replies: 4
    • Views: 248
    04-03-2013 05:49 PM Go to last post
  29. Runability

    Hey guys I have a 1978 VW Rabbit 8v manual trans car. In the last day and a half, including this morning when at idle or slowing down I hear a...

    Started by ASE82, 04-03-2013 09:42 AM
    • Replies: 3
    • Views: 248
    04-03-2013 10:33 AM Go to last post
  30. 1990 jetta won't start after changing headgasket

    So my jetta recently blew a headgasket, it would still start of course but ran like ****. So i changed the head gasket and now that I've gotten...

    Started by anthonyleehamilton, 04-02-2013 11:35 PM
    • Replies: 1
    • Views: 160
    04-02-2013 11:39 PM Go to last post

+ Post New Thread
Page 3 of 4 FirstFirst 1 2 3 4 LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts