details of motor: 1.8L, 8v, CIS-E, running a swapped digi head off a 92 gti, recently rebuilt, tt266 cam. keep in mind, to run this head, i don'...

So I bought NOS CIS injectors a while back and would like to replace the injector lines when I do the injectors if possible. My banjo...

Does anyone know what the ohm reading for a full tank and an empty tank would be for a 1982 VW Scirroco?????

I'm swapping in an Aba into my car. The block is completely bare. Would the intermediate shaft from my 1.8 fit? If it does would I still need the...

Hey guys, took the head off my 8v and replaced the valve stem oil seals. Now it is ticking. I spun the camshaft to see if I have a stuck follower...

I just bought another old VW it came with a lot of junk parts and a few gems among it all was an MSD 6AL ignition unit. I'd like to here from those...

Hi...can anyone please educate me on what is megasquirt? Is is possible to be on 1.8 8 valve cis engine? Or if there is a link that I can look into....

Link doesn't work and I need to replace it tonight!<p>Someone Help me!

Hi...what 2.0 8 valve engine is the best to swap over? I have a 1983 rabbit gti and I wanted a very reliable and very strong 2.0 engine...please help...

http://www.rpmmachine.com/shop/index.php?l=product_detail&p=4794 or...

Hey guys. Ive been having a lot of oil pressure issues with my mk2 8v. I diagnosed it as a bad oil pump. At idle, it would run ok, had pressure. Once...

Hey guys just want to see everyone's set up so lets see them <IMG NAME="icon" SRC="http://www.vwvortex.com/zeroforum_graphics/biggrin_upper.gif"...

Does anyone manufacture wiring harnesses for these engines? I just picked up a 1985 GTI and the wiring is complete junk (wire nuts, gobs of...

I don't have time to rebuild an ABA and swap it in. I want to put an ABA head on my digi block, what needs to change on my digi to make it work? ...

I have an 86 Scirocco with an 8v I had put on new plus, wires, distributor, rotor and I had just cleaned the rotor cap butstill no spark does anyone...

I´ve seen a lot info about the regular 8v-head and have seen diferent versions from Schrick, GMP etc. Did any company build a decent 8v crossflow?

I recently bought a 1990 Cabby for a few hundred bucks with the intention of just doing a quick head gasket and radiator. Low and behold the engine...

I have an 86 golf 1.8 that's carb'd. When I rev my engine my radio cuts out. It doesn't shut off(stays lit). Doesn't do it when I'm idling or...

i have to replace the 1.8 8v in my 88 golf , and don't have a spare digi head. i do have a late cis head that has the port for the air shrouded...

I need a new exhaust mannie and have a Aba one laying around will this fit with no problem?

rebuilt 8V motor in my 1990 Golf GL oil light is flashing checked the oil pressure at the sensor on the right side of the head and it read 0 ...

I understand on high lift cams, it's a good idea to have heavy duty springs, but as the G Grind was the Euro cam, would the stock springs be good...