Hey guys, Motor is running as good as possible with no timing advance, like crap. I'm runnung MSD ignition. I have the stock distributor with...

IDK how to upload images :(

I have a scirocco 16v whose engine I fully built. I have ms2 pcb 3.57, and a cabriolet carat. The engine and ms are going into the cabby. My question...

SOLD!!!!!! https://lh3.googleusercontent.com/-DxQ5hvUBAAk/TqLeFKukzuI/AAAAAAAABbQ/rVpybPL3qfo/s640/DSCF2531.JPG ...

Hi, I have my 12v VR6 set up with MS2v3 and it seems to be all good throughout the rpm range (i've slowly taken it up to 3000) if i rev it with the...

So I've had this GlowShift Wideband in the car for awhile and It works just fine. Now the Gauge is analog and the controller does NOT have a...

When switching to Megasquirt , what do people do with the carbon canister and evaporative emissions control valve? Can they be eliminated? I know...

Hi all, A quick one: I have a Carter fuel pump for my carbs project (twin DHLA on 1.8 8v). Where sould I place it? In the engine bay, or near the...

Alright, can someone explain this to me real quick. In my searches for various length velocity stacks I've noticed that with the stacks for Weber IDF...

Aside from other tuning issues my car will not start in the cold weather. I read a few old threads where need a vr6 mentioned 300% at 32 degrees,...

I am currently rewireing my ms. And have it all good except getting ms to control the fuel pump. I have never used ms to control fuel pump I always...

so now I know the crank sensor 3 pin connector is slightly bigger (.933" wide 6mm pin center to center) than the standard 3 pin connectors (.850"...

Well this is my attempt to make a plug and play harness for my 95 VRT Cabrio that I have been working on for a while. Just got my megasquirt setup...

Hello all, I'm in the process of putting together a 9A 2 liter 16V from a Passat. The head will be sent off this week for fresh seals. a 3...

Gentlemen, I have a question that bothers me. First of all: 1.8 8v engine code EX factory carburetted. So I'm about to switch from the...

Are the needles interchangeable between different seats? In other words, could I use a needle that came with a 250 seat in a 200 seat? I looked at...

Ok so I have a vems v3.6 ecu using the oem 60-2 vr crank trigger setup on my 1.8t. The car used to run great. I redid my harness. Pretty much just...

So I still have points powering my Cabriolet at the moment and was thinking how nice it would be to never have to worry about point gapping and burnt...

This is only as a temporary thing as i get everything for megajolt or something else. Iv heard that the stock ignition module from a 91 j/g with...

I've got an A2 with an ABA swap on MS. I just did a A4 intake manifold swap less than a week ago and as of yesterday and this morning my car is...

I am putting together a 16vt and wanted to know if if my ms can work without the vw icm. Ideally just the ms - coil - and hall dizzy for ignition. ...

so on my 83 rabbit i recently switched the stock carb to a weber 32/36 the problem im having is it seems like the float is getting stuck about once a...

Ok so trying to get my rocco started after the ms install. I'm getting fuel but no spark. On megatune when cranking it says not cranking and has no...

Okay so, I know that they are cheap ITB's, but they are not too far off from the real thing. They do need to be played with but the problem that...

lost all my data , naw my car is runing floded ,afr gauge is runing pass 17 untill it goes ---- does any one have a factory tune set up that can...

Hi all – as my FI build slowly approaches mechanical completion, the reality of my engine management’s status seems to become more and more daunting....

A little time ago I bought a MkII Jetta wtih a system named "Ecotronic" attached to it's engine. I tried to search internet for some information...

Does anyone have some advice on how to convert mk4 vr6 to drive by cable?

Last fall I swapped an aba with wring/ecu into my 86 westy an its been running great. I decided to put r1 carbs on it using stock ignition, just...