Long time since my last post. Well, like it says, a MKIII Golf rear axle will fit in a Fox? It looks like the same axle, but looking for some info...

Ok, so I've been talking back and forth with Felipe at iMohr and it looks like we can get the window seals for ~$50 per set (one set does both driver...

Talking about the front doors here, not the rear fixed glass. Tried being as careful as I could, but just couldn't get them to come off in one...

Well in my previous thread i totaled my fox friday night.. Now the front end is ****ed but the engine is perfectly fine exspecially since i did my...

Well guys.... My black 93 fox GL has been totaled last night.... I was driving down summit bridge northbound when a construction barrel from the...

Several other forums have a thread like this and it can be fun to read what other have done to theirs on a day to day basis expecially in a small...

http://gallery.achtuning.com/main.php/d/47259-4/3428b.jpg Achtuning now has BBS RF 320 wheels IN STOCK!! These are a 4×100 bolt pattern (cone...

http://www.x2industries.com/volkswagen-1987-1993-volkswagen-fox-complete-air-suspension-kit-p-5851.html?utm_campaign=googleproductsearchusen&utm_mediu...

This build thread has been a long time coming. When I first got the Wagon - I had no intention of it being worthy of it’s own thread (the car itself...

havent seen too much threads about 2.0 ABAs into Foxes. but here my build goes. today i pulled a running OBD1 ABA out of a running 4 door golf. car...

Anyone bring there Fox down to Sowo. Please share some photos.

Hi all, looking at an 88 Fox GL (4 speed) with 140k miles on it. Interior and such are pretty good, same with the exterior however I noticed a couple...

I'm in Portland OR for a little while and was looking to hit some good junk yards. Anybody have any suggestions?

So I'm working the bug out of Fox #8. For the most part, it runs fine, except under sharp left turns. Under accel, decel, doesn't matter. Under a...

I had it written down, but now I can't seem to find it anywhere. I'm finally getting around to installing my brazilian h4's on the two-door. I...

Where could I get one? Looks like I will need to replace to pass smog for regisyration...

ill start off by saying ive never owned a fox. it seems they are very similar to a mk2 golf with a few little differences. the reason i'm posting...

If I feather the throttle at around 2500- 3000 with the engine fully warmed up I'm getting a rattle. It sounds like when a timing chain gets loose...

Does anyone have any experience with the iMohr stabilizer rod? We are having nothing but problems. There is now a brand new transmission in the...

So after our 3A ingloriously ate itself after 10 laps and is likely a doorstop at this point, we are looking for more power and tuneability. As well...

My Buddy Mark happened by an auto wrecker and saw this car and immediately thought of me...pulled a U-turn and went inside and bought the car for me,...

I just purchased the 034 motors let's engine mounts and realized it dosent come with the front mount by the timing belt cover. Anyone know what this...

So thanks to tanking the motor yest again I will be doing an impromptu last minute swap of a 3A into our Fox race car to have it ready to race next...

Well after just installing my new 8000k HID's i was driving home the back Darker way home after dropping my friends off when my battery dummy light...

So I've just rebuilt the motor again after blowing the head gasket again racing it. We have a Techtonics 276 cam in there. Had the head done and...

I have a 93 Fox coupe that has the rear vent windows but the "driver side" latch is broken... I am looking for a replacment......... This is...

hey guys, I went through all the suggested testing procedures. My Bentley says to test the fan switch located at the bottom of the radiator by...

Thought I would start this thread, so if someone finds something they could pass it on. Greg W Sent from my PC36100 using Tapatalk

Just thought I'd let everyone know. There are four foxes in junkyards nearby me right now.:laugh: I could grab things for you if you'd like. I'm...

So my 93 fox just developed a w/s leak and I'm wondering if anybody has a cheap fix or am I cutting out and replacing metal. I haven't pulled the...