Sold http://img.photobucket.com/albums/v301/MattGreeneVA/222222.jpg ...

as it says. rebuilding my vr, spun a rod bearing. looking for one good used rod shipped to Portland Or, or local. lmk

trying to sell complete motor with everything but if If need be ill part out. its a 2.0 bottom with 1.8 head. head is freshly rebuilt and motor...

Selling my OBD2 thermal coated Schrick manifold. Worked great for me and gave great power and torque gains throughout the powerband. It is thermal...

SOLD!

I have an obd1 swap, with new clutch, chains, water pipes and parts.. new plugs wires, upper gasket set. ect.. CCA trans, with shiftbox, passat...

SOLD Forsale 12v lower manifold, looking for $30 plus shipping

SOLD:thumbup: As title states, I have a 2.8 throttle body for sale. Looking for $45 shipped.

hi im selling a running bio diesel engine out of my 81 caddy pickup. it has about 200k on it and still has great power, and can sell the 5 speed...

WTB: R36 intake manifold, ecu, wiring harness.

Hey guys this motor came out of my 95 jetta its a 12v vr6 with HD valve springs had about 120k on it when pulled the motor ran but it was knocking...

Its in good condition, i don't know how much these usually go for so throw a offer at me

sold.

Motor has 15k original miles on it i have a video right befriend I pulled the motor $1000 firm no exhaust mani or turbo

I am looking to pick up a set of webbers or delorto with intake manifold email butlerjona@yahoo.com

I had this for my Vanagon Project but I don't have time for a third project. It is an ATC out of an audi that had 82,000 miles on it. Sold

For sale is an aluminum fuel rail with an aluminum mount for a pressure regulator. As can be seen the fuel rail was manufactured by Racecraft...

revised cam, high pressure pump, cam girdle bolts, valve cover gasket, chain housing gasket. cant find the follower but those are relatively cheap......

Like the title says, I need to buy a set of 82mm stock compression ratio pistons for a 1.8L PL engine and 1.8 16V head. The head can have bent valves...

Sold.

**SOLD**

Here they are: http://i3.photobucket.com/albums/y76/suburbangeorge/P10116252.jpg ...

sold

Hey guys this motor came out of my 95 jetta its a 12v vr6 with HD valve springs had about 120k on it when pulled the motor ran but it was knocking...

Im looking for a built or semi built jh,1.6,or1.7 thats set up for carbs.The closer to nj the better. ...

120 shipped Pm me for info. http://img.photobucket.com/albums/v230/TimmyAndHisVW/IMG_0140-1_zps97e88185.jpg

anyone selling vr6 12v racing camshafts?

everything is OBO. from an 02 jetta BDF all emissions parts starter intake manifold fuel rail just ask me.. i basically used the longblock...

Just as the title descbribed, looking for a aba 2.0 block with the stock or upgraded internals for turbo. I need a new block with upgraded internals...

If anyone relatively near to las vegas has a cross flow head im looking for one to fit a 1.8 gti block for a bike carb ITB setup. thanks!