FS Item: Innovate LC1 Controller Description: Innovate LC1 Controller to hook up to Standalone (includes O2 Sensor) for closed loop A/F...

FS Item: Drive By Cable Conversion Kit (TB, Pedal, throttle Cable) Description: Drive By cable conversion kit to convert any 1.8T from DBW to...

I have a 034 motorsports vr6 engine cradle that I purchased in 2011. I have since sold all of my parts for the project which I regret, but this is...

All parts came off an obd1 vr6 with 71k original miles and all are in perfect working condition. All prices are best offer and do not include...

F/S VR6 Long block AAA no accesories 94,000 miles out of a 92 corrado distributor motor (real easy to swap to Coil pack motor) The story is...

I have 2 for sale 1 has apprx 170,000 miles and the other has apprx 110,000 miles 100 for higher mileage 150 for lower mileage OBO Text at...

parting out a 67k mile '06 2L fsi engine that the timing belt broke. looks like all the damage was two bent valves. crank is being sold in a...

Block has 63k miles hydraulic chain adjuster failed needs valves picked up in Newton NJ $600 obo

I have a 2.5 5 cylinder for, came from a 2012 passat with 112 miles on it.. It has a damaged rocker on #3 cylinder. The valve did not contact the...

I have a 1.8 16v complete with alternator ac compressor and all the trimmings minus cis lines.. I parted out a car that i couldn't get title for ....

Delete . http://i1281.photobucket.com/albums/a520/HoppinHoopty/2013-03-24144725_zps85eaf00f.png...

located in San Diego..$250 picked up, or you cover ship.. block p/n 053 103 021B.. head p/n 051 103 373.. ...

I'm not 100% sure whether this is off a PL or 9a motor, but I have a ported and polished 16v head for sale. It has not been ran since the work was...

sold. http://img.photobucket.com/albums/v616/etmracing/008-6_zps09f8ab02.jpg ...

As title states, going a different route, all in good condition and working order, $150 shipped for dizzy, cap, rotor & wires. $50 shipped for 16v...

No pics right now, but I'll get some with my friend's iphone. Pulled from a wrecked 2007 A4 Avant that was rear ended hard. Was going to be a swap,...

I have these motors listed for sale as complete but i will also part them out. Lots of good parts. Just pm me with your needs and i'll get back to ya...

Have a 01 Gti 12v vr with 116k on it parting out whole car 700 obo for complete motor

TT 260/264 cams for 12v vr6. Brand new. Never opened. Comes with cam alignment tool. Nothing else pictured is for sale. Thanks!! $390.00 shipped. ...

I sold a head on here last month and the guy started a claim against me because the machine shop said it needed valve stem seals and was not ready to...

Debating on whether or not I really wanna complete this swap since my rabbit only has 15k OG miles on it. I essentially have a complete front end...

All parts are for a 12v VR6. Timing covers: $20 Pistons + rods + new rings + new bearings (one bearing might be scratched): $100 ARP hardware...

Rebuilt OBD1 Block w/ Pistons & Rods (New rings bearings, Arp rod bolts) - (no oil pump or pan) $700 (SOLD) Rod Bearings & Mains W/ Piston...

Up for sale, is my 50MM intake, injectors, TB, and idle stablizer. All are in good, working condition. Parting out my 16V Cabby and these are the...

I've had this engine in a few cars, but never ran it for more than a few minutes. It has been sitting in my garage all Plastic Wrapped for a year or...

I'm parting out a 1.8 16v engine out of a 87 GTI. I recently bought this car but it's been sitting for about 9 years. I don't know anything about the...

I keep changing my mind, so I'm putting my carb set up for sale. I will ONLY sell as a package. ONLY 16v 1.8 140k full engine w accessories...

Looking for a 2.9 vr6 motor with wiring harness.

Selling both of these early vr isv. The one looks very new. Pick up both with the muffler and hoses for 100 shipped. ...

Stock rods with arp hardware. Hardware is brand new, never used. $90 shipped in the continental US ...