Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: rgarjr

    Page 1 of 13 1 2 3 4

    Search: Search took 0.43 seconds.

    1. Replies
      6
      Views
      362

      2 comps will fill up your tank quicker. I have...

      2 comps will fill up your tank quicker. I have e-level so it's a bit different to wire up but I just have a thick cable from the battery to a Stinger 80amp relay.

      I think V2 has the harness setup...
    2. Replies
      4
      Views
      327

      Yes relays can fail as they are mechanical parts....

      Yes relays can fail as they are mechanical parts. Even solid state parts can fail as well. In order to test your relay is working properly you need to get a voltmeter and measure up some voltages. ...
    3. Poll: The VU4 is a good manifold. Have had zero...

      The VU4 is a good manifold. Have had zero problems with it and it's very compact.
    4. It's been a while since I connected my Touchpad...

      It's been a while since I connected my Touchpad to a computer but it did light up the LED buttons
    5. Actually it's not that bad. I had my alternator...

      Actually it's not that bad. I had my alternator go bad on me to a point where it stalled the car. Also, battery would frequently drop low and had to jump the car. ECU worked fine and didn't lose its...
    6. Replies
      1
      Views
      373

      Grab a soap and water bottle and start looking...

      Grab a soap and water bottle and start looking for it. Could the bag, fittings, line, valves.
    7. Replies
      3
      Views
      413

      Hole should be bigger than the shaft, so yeah it...

      Hole should be bigger than the shaft, so yeah it looks okay.
    8. u need to check the compressors relay with a...

      u need to check the compressors relay with a voltmeter to see.
    9. Replies
      6
      Views
      725

      Where are u getting the 12V battery from?

      Where are u getting the 12V battery from?
    10. I think any battery specs would work on the v2. ...

      I think any battery specs would work on the v2. If it's good enough to run your vehicle, it should be fine.
    11. Replies
      4
      Views
      535

      That rub mark looks pretty deep on there. These...

      That rub mark looks pretty deep on there. These bags can also leak internally and of course there's no way to see it.

      Doesn't look like they've only been used for 1k or maybe he used them for...
    12. When bags go out they would most likely develop...

      When bags go out they would most likely develop slow leaks. They rarely just blow out, unless it's rubbing on something.
    13. Replies
      12
      Views
      972

      Never heard of that digital pressure sensor...

      Never heard of that digital pressure sensor leaking before.
    14. Replies
      21
      Views
      1,397

      Check your fuses and check to see if there's 12V...

      Check your fuses and check to see if there's 12V going to the comps with a voltmeter.
    15. Replies
      4
      Views
      641

      You can probably do some voltage checks with a...

      You can probably do some voltage checks with a voltmeter. Try swapping the sensor and see what it does.
    16. Thread: Leaking tank?

      by rgarjr
      Replies
      1
      Views
      381

      yeah PSI will vary depending on the temperature,...

      yeah PSI will vary depending on the temperature, but not a whole lot. I suggest you put a gauge on your tank to make diagnostics easier.
    17. Replies
      4
      Views
      566

      Suck broh. You can definitely damage the ECU if...

      Suck broh. You can definitely damage the ECU if u short out the wires on the USB cable.
    18. Replies
      22
      Views
      2,783

      They were thinking of an iPhone wifi controller...

      They were thinking of an iPhone wifi controller but I guess abandoned the idea. You could probably use the Zaetech TouchBox if u can tap into the valves.
    19. Replies
      2
      Views
      565

      There's really not much maintenance u can do on...

      There's really not much maintenance u can do on the e-level. Just make sure your connectors are secure. Sensor bolts and links secure. Wiring secure and not rubbing.
    20. Replies
      2
      Views
      703

      The top plate is a circuit board so I'm pretty...

      The top plate is a circuit board so I'm pretty sure the ground is common for all 8 coils.
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4