Type: Posts; User: TheDeckMan
Choked on my Pepsi...Well done :thumbup:
Still need the measuring equipment and software to design the part you intend to print. Beginning printers are in the $2-3k range in the more reliable setups. The $800 ones you speak of are not like...
From my experience it is still a far way off. Most people do not have the $3-10k in order to have a play thing to make an occasional plastic part.
I find it funny that the OP was warned yet still did it and complained. HP+'s are not even that crazy in compared to Padgid RS4-4's or Racing brake compounds. Granted they will rip your...
Possible peak saturation of cheap products? People have so much stuff its insane, I personally think consumer products on the cheap non-durable goods has started its decline.
Interesting point of...
Either the axle nut was not torqued properly, the bearing was cheap and did not have enough grease in it, the hub is bad, the spindle is bad or when pressed together it was pressed in wrong.
Yeah, should be a good shake down :laugh: TT's road trip so much better than the 911 :eek:
Yeah, other than moving it in and out of the garage to do other work I have not started tearing into it. Work and some house work has been keeping me busy. Shooting to do everything in the next three...
Nice progress Brad [emoji106]
Had a good time! Count me in for some karting.
The rear seat delete looks great :thumbup::thumbup:
Looking for the awkward car guys in a corner undoubtedly wearing blipshift or some other automotive shirts?
See you guys tomorrow :thumbup:
I have always used 15w-50 on VR6's and 5w-40 on 1.8t's and 10w-60 on the track cars. Try out Rotella T6 5w-40. I ran Motul 5w-40 on my 911 and it made tons of extra noise, went to Rotella T6 under...
1000-$1500 range max unless it has some super rare goodies.