Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: dubluv2003

    Page 1 of 13 1 2 3 4

    Search: Search took 0.61 seconds.

    1. Replies
      236
      Views
      22,915

      If memory serves me correctly, you need the...

      If memory serves me correctly, you need the shorter stroke, and the inserts come with new nuts for the top.
    2. This ^^ Speaking from experience I have...

      This ^^

      Speaking from experience I have learned the hard way that tunes are very specific and require certain hardware to run properly. Talk to Unitronic about the k-04 tune, it runs pretty much...
    3. :thumbup::thumbup: Perfect height and all that.

      :thumbup::thumbup: Perfect height and all that.
    4. Replies
      11
      Views
      355

      :laugh: Same, havent been on here near as much...

      :laugh: Same, havent been on here near as much lately.. and still they ask the same question over and over and over again.

      http://images.rapgenius.com/cqt63li4y604o9k3nzore4i7q.500x350x10.gif
    5. 4 coilover installs, 2 cup kit installs, and I...

      4 coilover installs, 2 cup kit installs, and I have never used a spreader tool. Lube that strut up and pound it in there. :beer:
    6. Replaced the relay. And yes it can communicate....

      Replaced the relay. And yes it can communicate. So logically I imagine the ecu isn't the cause went ahead and pulled the engine harness, gonna put a new one in. I found a few more spots once I pulled...
    7. Replies
      19
      Views
      745

      :( :wave:

      :( :wave:
    8. I can check resistance but thats about all I know...

      I can check resistance but thats about all I know how to do. I suppose I would need to bring in some help to do that, unless its relatively simple. Im not much of an electrician.

      Edit: Just did...
    9. Checked all relative fuses. Nothing busted.

      Checked all relative fuses. Nothing busted.
    10. Is my ECU fried or am I missing something?

      Long story short, I was experiencing constant misfires on cylinder 3. After looking into it, it was due to a cracked rad support my coolant fan sheared my wire harness. Replaced rad support, covered...
    11. Replies
      4
      Views
      275

      It was replaced because it quit working, relay...

      It was replaced because it quit working, relay and fuses were fine. But that was more than about 2 months ago.

      I guess I should also mention that I just got done repairing my wire harness from...
    12. Replies
      4
      Views
      275

      Wouldn't the immobilizer light be blinking?

      Wouldn't the immobilizer light be blinking?
    13. Replies
      4
      Views
      275

      Fuel pump primes then shuts off.

      As the title says the fuel pump primes for a mere second when you turn the switch to on. It normally pumps about 3-5 seconds. This is a new Bosch unit (1 month old). The pump is obviously getting...
    14. Replies
      1,891
      Views
      48,191

      Damn, that is a killer deal. To bad they are...

      Damn, that is a killer deal. To bad they are little wide for mine.
    15. Replies
      25
      Views
      430

      MOtor mount spacers would serve you better.

      MOtor mount spacers would serve you better.
    16. Replies
      25
      Views
      430

      From my experience and others, you are better off...

      From my experience and others, you are better off with out one. Just watch where you are driving.
    17. Replies
      4
      Views
      338

      Clay bar the roof. Also get that boser painted,...

      Clay bar the roof. Also get that boser painted, it will look so much better. Nice car.
    18. Replies
      20
      Views
      590

      On point. :beer:

      On point. :beer:
    19. Replies
      13
      Views
      397

      good thing about them is when they blow you can...

      good thing about them is when they blow you can make a hybrid coilover with adjustable damping.

      http://forums.vwvortex.com/showthread.php?5811535-hybrid-coilovers
    20. Thanks again got them all connected and soldered...

      Thanks again got them all connected and soldered up. I used liquid tape to seal them. Resistance is perfect on the injectors which are the wires that needed replaced. Now I just gotta button every...
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4