Type: Posts; User: haf1zur
Connected to the Reverse Gear Switch?
not sure if they do them in the US
but i have this:
G40 is the camshaft position sensor towards the front of the engine
Is it loose?
Do you get the same error when the cable is disconnected from the connector?
Looks like i will be fine with these
They are longer than the OEM stock bolts even with the nut and washer attached sitting flush
As you can see from the two pics below:
Will look into those
Going to double check the stud lengths of the ARP ones first, dont want to spend if i dont have to
If I dont use the washers they will sit flush, ARP...
you can do them yourself, its fairly simple
all you need is m12 male - female studded rose joints on each end and a metal bar
had a company over here make them for 80 pounds for a pair
If i remember correctly it was ArrowPrecision i got these off, was a while back
Remember making sure that the 3.2 was listed before hitting the buy button
Climiefish, is it the RWE 2002 for the...
As you can see in the below pic, the stud fits too far in and the nut is not holding the stud flush, spoke to arp and they said they dont do a kit for the 3.2 and that the one i have is for a 2.8
Which kit please?
I have 204-5403 and it doesn't fit by the looks of things
What are you using for main cap studs?
Wondering whats available
Fitted arp bolts to the main caps and noticed that the nuts dont cover the bolts flush
Is it safe to run like this or should i remove the washers?
Just back from the machine shop
The piston does not come close to that part so was told its all good
about and inch and half above that i can see the marks from the bottom of the piston...
Not a valve, i think the the rods hit the side of the block at the bottom of the piston champer
two chips missing from the area circled below
Was taking apart my spare block and found this:
Saves me money not doing it
So just the piston tops, valves then
I have a 2004 Golf R32 3.2 VR6 Engine
I am wanting to get my cylinder block ceramic coated, it has been bored and honed for oversized pistons
I wanted to get it coated, but...
Does it still do that if you take the window all the way up and then down by holding the button pressed?
It sometimes happens but after a couple of closures it starts to work again, i think its a...