Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: petethepug

    Page 1 of 13 1 2 3 4

    Search: Search took 0.64 seconds.

    1. Bosch cornered the market on this one. Bentley...

      Bosch cornered the market on this one. Bentley says to replace the VR's dizzy when it goes bad. There hasn't been much posted on replacing the hall sender though.

      The only reference I found was...
    2. Don't install an upgraded m/c two times. Put in...

      Don't install an upgraded m/c two times. Put in the 25mm Audi m/c once or your brakes wont grab til their almost at the floor using the Passat unit. The 25mm Audi units from the 94-97 A6 & 90-93 Audi...
    3. Both lines have a M10x1 female coupling so your...

      Both lines have a M10x1 female coupling so your good there.

      The Corrado lines are 435mm vs. the Mk IV (dual pot) R32 lines at 580mm. So no, don't use OE r32 lines. Can't remember, but either ECS...
    4. Replies
      6
      Views
      421

      Good Lord I want those!!! ...

      Good Lord I want those!!!


      http://img.photobucket.com/albums/v87/bobbyshreds/Justwashed.jpg
    5. Just came across this thread .. had to debunk it....

      Just came across this thread .. had to debunk it.

      The 2.0L 256mm vented rotors are 10.63lb.
      The VR6 280 mm (Corrado VR6 too) is 12.66lb.

      Unless you go with RB (Racing Brake) BBK four pot...
    6. Option 3a: 12/Seat Ibizia Cupra found on Seat...

      Option 3a: 12/Seat Ibizia Cupra found on Seat Ibizia Cupra "R"from 1999 to 2002
      http://www.partsbase.org/seat/ibiza-st-ib-eu-2002-6k-2-000-001-6k-2-199-999-61531-disc-brake/...
    7. Replies
      9
      Views
      414

      Don't use the early Mk II Girling 54's from '88...

      Don't use the early Mk II Girling 54's from '88 on GTI/GLI and some Audi. They have smaller M7x1 vs. M10x1 bleed nips that tend to snap off in the caliper body. You'll also have pad clearance issues...
    8. Replies
      2
      Views
      72

      Good seller. Still rocking the g lader he sold me...

      Good seller. Still rocking the g lader he sold me 7-8 years ago after my TEC GT-1 exploded. Thanks for the Corrado love!

      Merry Xmas Steve
    9. Replies
      3
      Views
      101

      Zeb can get you a NEW one for $130 - $150. It's...

      Zeb can get you a NEW one for $130 - $150. It's dependent on the dollar to euro rate. The larger the order from VWCP yours is included with, the less you pay for shipping over the pond. He may even...
    10. Replies
      3
      Views
      229

      These wont last long

      These wont last long
    11. That would be a sign your clutch fork is bending...

      That would be a sign your clutch fork is bending or cracked. Maybe Meister Werks is doing another Xmas sale this year.
    12. Replies
      9
      Views
      580

      http://www.corrado-club.ca/forum/templates/fiblack...

      http://www.corrado-club.ca/forum/templates/fiblack/images/cccLogoRight.jpg

      Click on the CCC pic above to see the entire thread on hall sender woes.
    13. It's really hard to get an "F" rating from the...

      It's really hard to get an "F" rating from the BBB. The CarMax located in Irvine, CA down here has over 800 complaints and a "A+" rating. Also keep in mind that the BBB rating is worthless when it...
    14. Replies
      9
      Views
      580

      Did you check the hall sensor in the dizzy?

      Did you check the hall sensor in the dizzy?
    15. Only OE VAG parts were used to make those. The...

      Only OE VAG parts were used to make those. The last time I spoke with Aaron about these he said that they would of made more but all those OE VAG parts are NLA.
    16. Replies
      5
      Views
      357

      If you're going through flex pipes then your...

      If you're going through flex pipes then your motor mounts need to be checked and/or replaced. The rocking of the engine takes the flexi straw portion of the down pipe beyond what it can handle until...
    17. Replies
      39
      Views
      1,804

      Recall RT15. A known issue from steering racks...

      Recall RT15. A known issue from steering racks failing in cold climates from corrosion. I spoke to VW about it and they asked all the disqualifying questions 1st. Do you live a warm climate? Has your...
    18. I'll let the cat out of the bag on the g60 cables...

      I'll let the cat out of the bag on the g60 cables ....
    19. Hey matey, the Corrado power bases are stamped...

      Hey matey, the Corrado power bases are stamped steel and will allow the seat to bottom out on the floor. The Mk II version like these will raise the recaro seat almost 2" off the floor in the lowest...
    20. Hey Jason, Hope you can confirm this. The...

      Hey Jason,

      Hope you can confirm this. The liquid filled version of this mount (8D0199379S) from the TDI/code AHN is going in to replace the right side/front motor mount (1H0199609K / ES#1306780)...
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4