Sounds like a 16V
Type: Posts; User: nbvwfan
Sounds like a 16V
I am not dismissing CIS-Basic or CIS-Lambda.
If you have the parts try them out.
What I found in the few circular iterations is that CIS-(anything) can be run to handle N/A, and an auxiliary run to...
Thinking just now on this.
In your multiple teardowns, did you ever set/calibrate the upper/lower chamber metering screws?
These are located on the outside of the ports. From what I recall they...
Up to 84 used the CIS basic.
Is yours a cabby? You mentioned "little convertbile", if in fact you have a Cabby, you probably have CIS Basic or CIS Lambda (K-Jetronic).
The distributor is usually...
If #4 is firehosing, the pintle is likely broken.
You need to replace the injector.
To diagnose the distributor, try switching injectors around. If the flow follows the injector it is bad, if it...
Don't underestimate CIS-E.
You probably have read my thread.
What I have learned most was to use CIS-(_) for N/A and then add in programmable Auxiliary fuel enrichment control.
:thumbup: to your follow-thru!
You just need a "Not Built For Your Approval" Sticker to affix to the back window. If your at Sowo, you should be able to find one.
As for your build Montra, "Why...
$1000 for a running and driving and (from the looks of it) a decently intact body and engine bay is a good deal. Based on the contraband searched seats, see if you can barter it down.
^ is just clean and classic.
I think I will buy the VT type Magnaflow, just to see if what is said is true and I can run without a drone.
Mine is significantly reduced, and the .76 5th improved things...
Tank before last was 29.16 MPG in mixed to steady driving
This tank was 28.32 MPG in mixed to stop and go. Still have not reached 30 MPG.
BBM parts are finally to arrive today. It turns out,...
Glad you checked out the TTS.
I cannot say that one will not work over the other. I'd buy whichever is cheaper. It is there to perform a simple job for about 10-15 seconds.
Mine, I have wired to...
In for updates.
Really like the interior shots too.
Makes me want to do a swap in my 83 GTI.
If you are still looking for a Diesel fifth, contact Broke.
he sells all sorts of trans parts. I bought two .76 5th kits from him. Installed one, have the other NIB.
You might be...
I watched the recorded "Car Crazy" episode last night to get motivated.
4 weeks seems to soon for what I am trying to get done beforehand.
I ended up building a Rotisserie with two HF engine stands with structural additions and raised rotation point (about 8" too low still).
I know it is not what you were looking for answer-wise, but I...
They are adjustable, but you have to drill the cap to expose the screw.
It is a POT and can rotate as much as you like, but will go off scale, thus the adjustment being made only when you have a...
From my fiddling with that component about a year and a half ago, that potentiometer is primarily used for cold start.
In other texts I have read this resistance sends/influences a signal running...
I followed this guys video
Stage 1: 40Nm 29.5lbf ft
Stage 2: 60Nm 44.3lbf ft
Stage 3: Each bolt is taken through 180º turn