Type: Posts; User: Tofik
up for sale is a brand new never opened Hazard Switch for a mkiv golf/jetta part number 1J0 953 235J , if your blinkers are acting funny or don't work chances are your hazard switch needs to be...
i have th enoise in my mk4 with xls, I'm assuming the struts are dry or some boring is dry and its a low pitch squeak at low speeds over small bumps, took the bags off the struts and sprayed some...
z Lublina? jak tam drogi u was?
Idk about the switch but you want progressive spraying not just an on and off switch, you can get the snow performance controller separate from the kit and iirc it will cost less than the switch you...
Vag tacho software and cable
talking and sharing ideas and how tos is part of the community its not about going lower than everyone else.. if you can offer tips/tricks to those who ask for help then you're doing your part, i...
as he said.. Buy Nice, or Buy Twice:beer:
if the sheet says fail then you have to get it corrected, if the sheet says "unsupported" then unitronic is tuning out your sensors and it'll never pass, i have to get my revo file taken off so that...
does anyone know if a 2005 gli curtain airbag plugs right into a 2001?
check the rear lower control arm bushings..
because when it does fail it throws a cel and you can't pass with a cel, some fail but don't throw it, sai cat and eval will, so as long as the others pass but 1 test "hasn't completed" or been run...
Here it is for all you other folks
Adaptation channels for setting readiness.
Warm up the car with a quick drive, clear all codes then:
Go to : ***tip*** I used a 2x4 to brace against...
you can pass as long ass the cel isn't on, so reset , then run vagcom at the specific block to pass the sensors, sai is only tested the first time you turn over a cold motor, so run the car...
yea thats what i was going to do undo all 4 lines from the motor and not the turbo
50k miles running the small turbo hard took it's toll so it might be time to replace
so... Is it possible to replace turbo without pulling off exhaust manifold? Or does it all havee to come out?