Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: azthegame

    Page 1 of 13 1 2 3 4

    Search: Search took 0.61 seconds.

    1. Replies
      4
      Views
      203

      United Motorsport would be the best option, and...

      United Motorsport would be the best option, and their tune can be done via the OBD port if there is a dealer close to you.
    2. Replies
      3
      Views
      158

      When I had solo werks, I ran it with perch and...

      When I had solo werks, I ran it with perch and springs. The perch was bolted down and unable to move. No noises. I also ran it spun down as low as it went, no noise. I also ran them with no perch and...
    3. Replies
      3
      Views
      158

      Your perch bolted to the bottom or just sitting...

      Your perch bolted to the bottom or just sitting at the top? When I had coils just recently, there was a slight noise in the rear and when I took the spring and perch out and put drivers gear springs...
    4. I know it is probably common knowledge and...

      I know it is probably common knowledge and shouldn't have to be asked, but is everyone making sure they tighten the endlinks while at the same time making sure an Allen head is inserted into the...
    5. Replies
      27
      Views
      839

      The other most common source of clunking or...

      The other most common source of clunking or popping is sway bar links not right enough, and also the subframe bolts (not install related though)

      Your bump stops were cut properly?
    6. Replies
      27
      Views
      839

      If you didn't install upgraded strut mounts along...

      If you didn't install upgraded strut mounts along with your coils, then clunking is a common problem. The stock ones are junk with most lowered cars.
    7. Replies
      5
      Views
      289

      Look under car, remove the plastic under tray....

      Look under car, remove the plastic under tray. Look around the compressor to confirm your type. Also look for the actual rcv on the side of it. Determine if it is secured with a clip or a bolt. Once...
    8. Replies
      5
      Views
      289

      RCV RCV RCV RCV.. the most common issue with our...

      RCV RCV RCV RCV.. the most common issue with our AC.

      http://forums.tdiclub.com/showthread.php?t=422783

      Have it changed and it will begin to freeze your junk off on low fan settings....
    9. Replies
      15
      Views
      876

      I have the sel 2.5. I would trade for a new 1.8t...

      I have the sel 2.5. I would trade for a new 1.8t SE if I could.. In a heartbeat. More fun to drive in stock form and a lot more tuning and modding potential.

      Run away from the 2.5.
    10. Replies
      2
      Views
      245

      I am not sure about the TSI engine, but in the...

      I am not sure about the TSI engine, but in the TDI, there is an intake manifold flap motor that ends up being the culprit when that code is thrown. Have no clue if the TSI has something similar or...
    11. Replies
      10
      Views
      412

      It will blow hot if you leave the temperature...

      It will blow hot if you leave the temperature setting on hot. During winter, it's nice because if you leave it on hot it will flow the warm air, with no need to use heater. And if you switch it to...
    12. Replies
      13
      Views
      558

      It probably says turbocharged engine because they...

      It probably says turbocharged engine because they copy and paste the product pages of all their intakes and just change certain things like 2.0 8v, 2.0 16v TSI, 2.5 ETC.

      The intake for the turbo...
    13. Replies
      7
      Views
      759

      You don't want to just reattach the original one?...

      You don't want to just reattach the original one? Just buy some 3m automotive tape.. It's practically what the factory uses to apply all exterior trim pieces anyways.
    14. Replies
      13
      Views
      558

      Useless for this engine but here you go... ...

      Useless for this engine but here you go...

      http://www.goapr.com/products/intake_carbonio_20_8v.html
    15. Replies
      4
      Views
      481

      GTI had Dynaudio, not fender, am I right?

      GTI had Dynaudio, not fender, am I right?
    16. the only way to get 50HP is with integrated...

      the only way to get 50HP is with integrated engineering's power kit. But it only works on the Golf's 2.5L motor because the Jetta's has the power steering pump in the way to the left of the intake...
    17. Replies
      48
      Views
      2,632

      If both of them are pretty worn I agree, but if...

      If both of them are pretty worn I agree, but if both were in pretty decent shape and had good tread left when one blew, I would replace the one only, screw the extra 160+ extra for nothing. And I...
    18. Replies
      8
      Views
      278

      It's too new for it to be the fuse, yet totally...

      It's too new for it to be the fuse, yet totally old enough to be the actual outlets? Think about that logic.. Lol

      And it could totally happen if something fell in to the outlet and shorted the...
    19. Replies
      48
      Views
      2,632

      Couldn't replace just the one that blew out?!

      Couldn't replace just the one that blew out?!
    20. Can't believe nobody has stated that the rcv...

      Can't believe nobody has stated that the rcv valve is the most common problem in the MKVI AC system. It's located on the compressor and gets clogged and causes horribly intermittent cooling.

      Just...
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4