Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: cubano717

    Page 1 of 13 1 2 3 4

    Search: Search took 0.53 seconds.

    1. Replies
      13
      Views
      262

      needing an alignment after replacing steering...

      needing an alignment after replacing steering components is normal, doesn't mean i did anything wrong, i just wasn't lucky enough to put it back together and have alignment remain perfect. No big...
    2. Replies
      4
      Views
      231

      neeed helpppp

      There should definitely be a nut on top of the strut tower holding it in


      Sent from my iPhone using Tapatalk
    3. *:::::::the official what did you do to you mkiv today thread::::::::*

      How did you wire the mirror? I have one and wasn't sure how to wire it


      Sent from my iPhone using Tapatalk
    4. Replies
      13
      Views
      262

      Steering question

      I understand I need an alignment. I knew that before I started this thread. I didn't know why the wheels stay turned after releasing the wheel. I didn't know if that was due to not getting it...
    5. Replies
      13
      Views
      262

      Steering question

      So are you saying alignment would do that


      Sent from my iPhone using Tapatalk
    6. Replies
      13
      Views
      262

      Steering question

      I knew the alignment is off but it's like when I turn and drive the wheels don't straighten back out. I didn't realize alignment would cause that?


      Sent from my iPhone using Tapatalk
    7. Replies
      13
      Views
      262

      Steering question

      Replaced inner and outer tie rods, ball joints and LCA bushings. When driving now if I make a turn the wheel doesn't go back to center like before. I torqued the outer tie rod to spindle to spec but...
    8. Replies
      17
      Views
      302

      No start problems

      New engine speed sensor in and it started up.


      Sent from my iPhone using Tapatalk
    9. Replies
      17
      Views
      302

      No start problems

      Ohms were right under 700 on the engine speed sensor


      Sent from my iPhone using Tapatalk
    10. Replies
      17
      Views
      302

      No start problems

      Bump


      Sent from my iPhone using Tapatalk
    11. Replies
      17
      Views
      302

      No start problems

      Are there any other sensors or anything that prevent the coil packs from firing the spark plugs?


      Sent from my iPhone using Tapatalk
    12. Replies
      17
      Views
      302

      its manual and the sensor is on the block, under...

      its manual and the sensor is on the block, under the oil filter.
    13. Replies
      17
      Views
      302

      all fuses look good. checked that all electrical...

      all fuses look good. checked that all electrical plugs are connected. I'm honestly not sure what to do. if anyone has any advice it would be greatly appreciated.
    14. Replies
      17
      Views
      302

      No start problems

      So could it be that the cam sensor wasn't bad after all? I figured that was the issue because of the fault code. Now I'm not getting the camshaft sensor code now just the engine speed sensor. Is...
    15. Replies
      17
      Views
      302

      No start problems

      Any other ideas?


      Sent from my iPhone using Tapatalk
    16. Replies
      17
      Views
      302

      new sensor is in and I'm still unable to get it...

      new sensor is in and I'm still unable to get it started. after trying to start it throws a code for engine speed sensor no signal. i think that may be caused after a no start.
    17. Replies
      17
      Views
      302

      timing is dead on, getting new sensor tomorrow.

      timing is dead on, getting new sensor tomorrow.
    18. Replies
      17
      Views
      302

      No start problems

      Replaced timing belt and related parts a few months ago. Everything ran well for about two months until Saturday I got a check engine light for camshaft position sensor too high. I cleared it and it...
    19. Replies
      7
      Views
      202

      thats not true i bough a single key from the...

      thats not true i bough a single key from the dealer when i stripped mine.
    20. Replies
      7
      Views
      202

      They aren't all unique, but there are various...

      They aren't all unique, but there are various keys across the mk4 platform, if you go to the dealer you should be able to get one or online.
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4