Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: euro+tuner

    Page 1 of 13 1 2 3 4

    Search: Search took 0.73 seconds.

    1. Replies
      9
      Views
      164

      Vortex requires you to upload your photos to a...

      Vortex requires you to upload your photos to a photo hosting site (flickr, photobucket, etc.) to share them

      As far as the lines I have no idea, sorry.
    2. Replies
      12
      Views
      436

      Vagfair is coming up! Let me know and I'll bring...

      Vagfair is coming up! Let me know and I'll bring them with :beer:
    3. Replies
      300
      Views
      17,322

      I should be able to grab some tomorrow morning,...

      I should be able to grab some tomorrow morning, and thanks!
    4. Replies
      11
      Views
      502

      There should already be a female spade connector...

      There should already be a female spade connector splitting off of your V2 harness which provides signal to your second compressor. I believe the wire is gray with a white stripe, and the spade cover...
    5. Replies
      300
      Views
      17,322

      I run et 25 on that exact size setup (so mine sit...

      I run et 25 on that exact size setup (so mine sit out 5mm more than what you're looking for). So if you are still looking for any (close) examples, there is an ish ton in my flickr linked below....
    6. Replies
      3
      Views
      135

      I don't think you did any damage to the bearings,...

      I don't think you did any damage to the bearings, considering you never even hit the manufactures torque spec let alone exceeded it. If it were me I'd swap to the correct sized hardware but I'm a...
    7. Replies
      30
      Views
      1,364

      Didn't mess with my tank or hardlines, so...

      Didn't mess with my tank or hardlines, so unfortunately I didn't snap any behind the scenes photos of my new setup.

      I did however pick up some caliper carriers at a junkyard; the last piece to my...
    8. Replies
      39
      Views
      2,143

      The system went on a mk4 four door golf. As much...

      The system went on a mk4 four door golf. As much as I love photography, usually when I'm working on a project I just continue hammering away at it until the end without stopping; so I literally only...
    9. I like a lot of bagged cars, hell I even drive...

      I like a lot of bagged cars, hell I even drive one. But I prefer the look of this one aired up.
    10. Replies
      12
      Views
      436

      :wave:

      :wave:
    11. Replies
      39
      Views
      2,143

      I just recieved mine on Thursday and am super...

      I just recieved mine on Thursday and am super impressed with all the components and little details thus far. I'll be getting started on my install today! :beer:
    12. :beer::wave:

      :beer::wave:
    13. Replies
      30
      Views
      1,364

      I did not, but I'm actually redoing the two...

      I did not, but I'm actually redoing the two hardlines tomorrow, so I'll have the panel off and can snap a couple photos while everything is apart and post them up.

      As far as the rest of the...
    14. Replies
      5
      Views
      328

      :beer:

      :beer:
    15. Replies
      12
      Views
      436

      up

      up
    16. Replies
      30
      Views
      1,364

      I feel like I haven't seen your username pop up...

      I feel like I haven't seen your username pop up in a while; good to see you're still around :beer:

      Also, yeah routing the supply lines was interesting to say the least. They are routed in the...
    17. Replies
      30
      Views
      1,364

      :)...

      :)
      https://farm1.staticflickr.com/353/20152820862_08f54c70f7_b.jpgAirLift H3
      by Evans89411, on Flickr
    18. Replies
      7
      Views
      311

      :beer:

      :beer:
    19. Replies
      7
      Views
      311

      You can run your front struts from your mk4 gti....

      You can run your front struts from your mk4 gti.

      The part numbers for the Air Lift Slam Series XL front struts are the exact same whether it be for a standard mk4 (golf/gti/jetta) or the R32 - the...
    20. Replies
      12
      Views
      436

      :beer:

      :beer:
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4