Type: Posts; User: 02awp18705
Not sure if this will help but this is what I have on my Corrado . I'm using FK streetlines with MT 24.5x8 . The wheels are 7.5'' wide with the stock Corrado offset . I can raise the coils high...
I had a hard time getting the air out of my 1.8t corrado also on ms2 . What worked for me was , let the car run for 30 seconds and crack the heater core line just a bit to let some air out . I would...
I have one PM me if you still need it .
Looking nice good luck with the build . I was looking at that turbo for my 24v .
Nice numbers sound like a good time . I'm always the only VW at the track . I just ordered the same size slicks they should be here in a couple days . What wheel's do you have ? I think I'm going to...
Nice 60' :thumbup: I cant wait to get some slicks and go back .
Did you use pin 37 for the fuel pump or fuel pump relay?
I forgot all about the MAT ignition timing . This is the first couple of times driving the car in the heat (80-90 degrees) . I did some adjusting on that and everything's perfect :thumbup:
Hey guys wanted to know if someone can take a look at my ignition table . I'm using MS2 v3 set up for waste spark . The car pulls ok but kind of flat up top . It's a AWP block and AEB cylinder head...
Do you still have these?
14.1@107/2.4/Corrado/1.8T/T3T4 57trim .63AR/93-Meth/Stock/195/50/15 ST/Rich Bitto/02awp18705
What's your location ?
I was going to try 205/50 15s on my 1.8t corrado . I'm going for the 450whp range . Are you going to Numidia for test and tune April 5th ?
What's your location ? Do you have any other info on this ?
How much for the steering wheel ? How far are you from Plains PA 18705 ?
Pay off my house and put the rest on red .
How much? Looking for any trades?
Is there anyone using the stock VW knock sensor with MS2 v3 . The only thing I found so far was a GM set up in the mega manual .