Type: Posts; User: xtremevdub
I wish I would have seen it before I removed the entire fuse box looking for melted wires.. :banghead: And I was looking for that because it died very weirdly.
First I was running in fumes.. So I...
Selling an Audi TT dead pedal in great condition. Only one broken tab.
Goes perfect with the TT pedals if you have them or looks great by itself. Fits all MK4's.
$50 SHIPPED to the lower 48...
Today I decided to spend some time trying to figure out why mine died about a month ago in the middle of a bridge in the pouring rain..
after a few hours of disconnecting and inspecting every wire...
See if pin 24 on your ECU throws a signal when you open ignition. The computer turns on the fuel pump relay and from there it goes to the fuel pump.
Could be your ECU.
This is not correct.. the pump primes even if the car doesnt run.. Or at least is supposed to.
To the OP, turn the ignition switch on and listen if the pump starts working for a couple of seconds....
You can use the tool to press it out or hammer it out.. I prefer the last method.
When you modify the HF tool, you end up using the 72mm tool and making it a tad smaller.. 72mm is the same size as...
That method takes too many tools that you have to "make" and it pushes the bearing back in by pressing the center of the bearing, which can ruin it easily. Plus it is very time consuming.
you have more pics of the motor??? that looks great :thumbup:
Is for a g60, but I dont think it makes much o a difference.
A1 and A2 from the fuse box forward. Uncut.
Let me see what you have you Corrado killers. :P
Did you ever send me those longer bolts?
Cant wait to install these. :thumbup:
If you get passat b3 parts, they can swap to the Corrado.. pedals, clutch, flywheel, starter, you get the idea.
you will need this when the time comes.....
ok.. last freebie..
(1).. the VR6 tranny were shifted by cables. like the Corrado G60 trannies. And their clutches were hydraulic unlike the ABA transmissions that were rod shifted and had a...
the engine will fit. You will need the full engine harness from the mk3 aba car as well and you will need to splice it and connect it to the corrado harness.. (mostly lights, hi/low, fogs and horns)...
I recently put a new pump on the car and can go to empty without issues.. the pumps inside have rubber diaphrams that when they are old, they disintegrate causing the pick up area not to work unless...
You got pm:thumbup:
Since you had both pieces out, you could have taking it to a place that does weld and have it done for like $20.. less headaches down the road.. :thumbup:
Why didnt you just weld that neck to the rad and called it a day?
You dont need to change the k frame, just the front x-member to use the hockey pucks. Your problem is the front not the back.
You could also keep your x member and go solid mount.
Bfi and bbm...