Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: MacGruber

    Page 1 of 13 1 2 3 4

    Search: Search took 0.79 seconds.

    1. The pressed in hub should hold it together, after...

      The pressed in hub should hold it together, after all the hub goes through both halves of the bearing.

      [However much force is required to press a new hub into the new bearing] - [that of the...
    2. What fuel pump is included in the FUEL ACCUMLATOR...

      What fuel pump is included in the FUEL ACCUMLATOR ASSEMBLE COMPLETE $60 SHIP?

      CAN you sell just the fuel pump holder?

      Plastic thing too maybe.
    3. The Bentley manual answers your question -...

      The Bentley manual answers your question - letting the car sit with no axles, zero compression of front bearings.
      See the the engine/transmission removal section.
      You can roll the car around, by...
    4. Replies
      6
      Views
      462

      I found out the hard way that enough fuel...

      I found out the hard way that enough fuel pressure to cause gas to spray out of the fuel filter fitting, does not mean it should start. The fuel distributor is supposed to be getting 78 psi from the...
    5. Replies
      6
      Views
      364

      I looked for used terminals, after a bad fuel...

      I looked for used terminals, after a bad fuel pump experience.
      1992 Audi 100 to the rescue.

      Extracting them from the plug without deforming them, not so easy.
    6. The clutch disk is for an 8v transmission, right?...

      The clutch disk is for an 8v transmission, right? I could just look up the numbers.

      What sort of shipping cost is from Germany to USA?

      The Classifed Forums for Scirocco Cabriolet etc -why not...
    7. Try the Hybrid Forum - engine Q's. Knock- mk1...

      Try the Hybrid Forum - engine Q's. Knock- mk1 forums: adding in 16V CIS-E , except of course the distributor issue. Do you have the CIS-E or DIGI ignition distributor required, that fits your...
    8. What' part numbers on it, maybe have exactly same.

      What' part numbers on it, maybe have exactly same.
    9. Replies
      20
      Views
      1,303

      So does it run, do you have the ECU, knock box,...

      So does it run, do you have the ECU, knock box, CIS-E fuel distributor, 16V air box?
      I'd think it would come with uncut wires from engine to ECU, Knock box at least.


      Coolant temp switch is just...
    10. Replies
      59
      Views
      3,565

      Here's a new request - I need the plastic clip...

      Here's a new request - I need the plastic clip for the rear seat back pivot pin. One seat pin fits in a hole in the body, the one on the other side is held by that clip.
    11. Replies
      20
      Views
      1,303

      New knock box is now expensive, so be sure to...

      New knock box is now expensive, so be sure to follow VW or Bentley wiring, because you will may FRY one using that wrong wiring diagram. . The wire to starter 50 (+12v) is supposed to instead ground...
    12. Replies
      2
      Views
      297

      533 955 407 B WIPER ARM ASSEMBLY including the...

      533 955 407 B WIPER ARM ASSEMBLY including the nut, washer and plastic shaft cover.
      F 53-K-005 282>>

      The OEM replacement number if your Scirocco has a VIN ending with a number higher than...
    13. Have: Cabriolet fuel sender with internal return...

      Have: Cabriolet fuel sender with internal return hose. Good condition. Even have the pump no guarantee on that.
    14. Replies
      3
      Views
      620

      Problems posting without checking that box are...

      Problems posting without checking that box are excessive, deterring visitors from posting.
    15. Spotted on a Scirocco in the junkyard a long time...

      Spotted on a Scirocco in the junkyard a long time ago:
      PVC tubing ~6 inches long, fits over the strut tube, can still close the hatch. Supports a shot hatch strut.
      Cost = 1 foot of 3/4" PVC...
    16. Yes - that is one of the steps BEFORE using your...

      Yes - that is one of the steps BEFORE using your Duty Cycle meter.

      First actually DO all the TuneUp steps, repeated for convenience.
      1. Vacuum Leaks including injector seals.
      2. Mechanical -...
    17. Which would you rather DRIVE on - these, or...

      Which would you rather DRIVE on - these, or newish stock springs in back.

      STOCK Springs have 12 coils:
      (6) coils are 11mm diameter 'bar' or ('wire'), and:

      At each end:
      (1) coil is 8 mm with...
    18. NO you mean the Bosch JETRONIC ECU - yours has a...

      NO you mean the Bosch JETRONIC ECU - yours has a RED label.


      That thermoswitch is a simple open/close switch based on the temperature stamped on it.

      If unplugged O2 sensor system is in...
    19. Available: REAR only H & R lowering springs from...

      Available:
      REAR only H & R lowering springs from the 54743 set - brand new.

      Someone only used the fronts.
    20. Replies
      2
      Views
      730

      1.6L with more horsepower than any U.S. mk1 -mk2...

      1.6L with more horsepower than any U.S. mk1 -mk2 1.8L- 8v engine:
      Free flowing exhaust, high compression, is all I know about them.


      Note that "Heron head" deal, different pistons too.

      Turn a...
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4