Type: Posts; User: AmIdYfReAk
Can't wait to see it boot! [emoji106]
Just awesome man!!! Can't wait to see this thing at full stride!
Here in Ontario, it's around $20 for it, anyone can get it .. Just supply the vin.
It shows name and address
Get VIN, go to DMV, Purchase used vehicle package, get owners name, track down, call, buy, own, fix/clean, burnouts, ????, Profit
Connect a transmission and starter and do a cold compression test after checking that it spins freely
It depends on what you're looking to do, usually when I do what your asking I just hook up the CEL wire to the OBD K LINE.
Works without an issue with generic scanners as well as Vag-com but its...
Merry Christmas to all! Happy boosting!!
If your getting that car flashed with the ecu thats in the car currently, no.
That service is for engine swaps, or when you're swapping ecus between cars.
Haha, try to find any of that in his audi....
If buddy got the car 3-4 months ago, what about the PO borking up a removal of the old CPS and left some copper in the block?
Anyway, who the hell cares? Its borked, swap or build and swap and...
No one out there looking for a cheap fwd transmission for a mid engine setup? =]
Or those people with crunching gears in a b5/b5.5?
You knnooowww you wana!
Drove and shifted fine,
It was in a 2004 passat 1.8t parts car i purchased to get swap parts for a b5.5 TDI 5 speed swap.
Located in london, ontario
Would need to be really motivated...
Seems i'm going to be that guy, but i've used this method 5 times and counting:
After each pull the vac run the engine was stronger and stronger....
Is it a Bosch sensor?
If so, check the bentley for the coolant temp resistor readings, they're the same.
If its a different sensor, it'll be a different resistance value table.
Ohm test the temp sender, or change the oil and put a larger filter on and note if there are differences in temps.