Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: jetta coupe

    Page 1 of 13 1 2 3 4

    Search: Search took 0.59 seconds.

    1. Replies
      13
      Views
      545

      Corrado vr6 airbox is a direct fit. Get a vr6 maf...

      Corrado vr6 airbox is a direct fit. Get a vr6 maf housing, and swap you're maf sensor into it. The intake tube should fit over that. If someone could confirm this, that would be great.
    2. Replies
      5
      Views
      280

      Did the strut mounts come with hardware? (Mk3...

      Did the strut mounts come with hardware? (Mk3 nut). If your using the mk2 nut between the mount and upper cap, it will make noise.

      Did the mounts come with new bearings? New mounts with old...
    3. Replies
      2
      Views
      242

      Cables follow the car. Order them for a 90 model...

      Cables follow the car. Order them for a 90 model with rear disc brakes.
    4. Replies
      8
      Views
      585

      I bought my wagon for 400. Needed a clutch, fuel...

      I bought my wagon for 400. Needed a clutch, fuel pump and shifter bushings. I drove it away from his house though. Pretty decent car. Few spots of rust here and there, but nothing major.
    5. Replies
      13
      Views
      1,025

      Bought them for my mk3. Low, not slammed. Have...

      Bought them for my mk3. Low, not slammed. Have plenty of threads left. I would say their the same as raceland. Seem to go just as low, ride about the same. Same warranty. Not bashing, I don't mind...
    6. Orange is probably my second favorite color on a...

      Orange is probably my second favorite color on a rabbit.
    7. With a 40mm offset, you should be fine. It sounds...

      With a 40mm offset, you should be fine. It sounds like you're doing you're homework, I just didn't know if you had looked into that tire size or not.
      You can go to tyrestretch.com to see alot of...
    8. Because you wheel choice is 6.5 " wide, I would...

      Because you wheel choice is 6.5 " wide, I would go with a 195/45/15 so you don't "fatten out" the sidewalls too much.
    9. You should be able to use the either injector...

      You should be able to use the either injector cup, as long as it is cis. I was told the 83 jh head uses smaller bodied injector cups, so as long as you have an 84 and later head, you should be fine....
    10. Replies
      44
      Views
      2,406

      I just installed a set on my mk3 last week. It's...

      I just installed a set on my mk3 last week. It's low, but not slammed. The ride is pretty nice. Firm and not bouncy. Good price and fast shipping.
    11. Replies
      11
      Views
      799

      Had this happen in mk1 and mk2's. Just a rough...

      Had this happen in mk1 and mk2's. Just a rough scraping kind of noise.
    12. Replies
      3
      Views
      520

      Fox wagon for sale

      I know this isn't the right forum, but I thought I would just put this here. He is a fellow member. Jeremy757http://tapatalk.imageshack.com/v2/15/01/15/2125c5ebd0b02d0c9c141c75c3fb1797.jpg
    13. Replies
      23
      Views
      2,709

      Hell yea! Glad it worked out.

      Hell yea! Glad it worked out.
    14. Replies
      23
      Views
      1,344

      You should be able to take the injector cup out...

      You should be able to take the injector cup out of a cis head, and put it in a digi.
    15. Replies
      23
      Views
      2,709

      There is a bushing where the shifter bolts to to...

      There is a bushing where the shifter bolts to to linkage. It's on the inside of the car. Take your center console out, and you'll see it. I shaved down some mk1 bushings till they fit. I replaced my...
    16. I have early 85 mk2 spindles, mk1 fk v2 coilovers...

      I have early 85 mk2 spindles, mk1 fk v2 coilovers and shortened tie rods. I had to grind the spindles to fit the mk1 coilovers. Then I cut the steering arms off the fox struts, and welded them on the...
    17. Replies
      5
      Views
      338

      I know this has nothing to do with your question,...

      I know this has nothing to do with your question, but what are the specs on the wheels you had on the car? They were flat black.
    18. http://tapatalk.imageshack.com/v2/14/12/27/251d1bc...

      http://tapatalk.imageshack.com/v2/14/12/27/251d1bc2c4cad3334a8c6589f7dee7b3.jpg I know the feeling. This was supposed to be just a daily....
    19. Replies
      12
      Views
      643

      Also check grounds on the corner of the valve...

      Also check grounds on the corner of the valve cover, and the battery ground along with the battery to body, and battery to transmission grond points. These are crucial ecu killing grounds. Something...
    20. Replies
      12
      Views
      643

      There is a ground junction to the left of the...

      There is a ground junction to the left of the fuse box, above the hood release handle. It was not really a good ground. Check the grounds coming off of that and go from there. My brother in laws car...
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4