Type: Posts; User: BlkdOutA4
I have 2 brand new Falken 912's. 195/50/15. still have stickers on them.
$100 picked up. Palmyra/Annville/lebanon, pa area.
I did speak with Chris and he was very helpful! I'm glad I went with c2, their customer service has been outstanding!
The harness and Ecu are out of a 97 b4 passat. I let it idle for quite a while and no other codes came up so I'm assuming there is still an sai relay in there? Couldn't figure out which relay that...
Ok....so I'm a complete idiot....I emailed Chris at c2 and he asked if I cleared the codes after installing the chip....guess who didn't do that! This dumbasS! After clearing the codes the only one...
just read a thread that says I cant use resistors being obd2??? i'm even more confused now. I just want this ****er to run right :banghead:
didn't even think about resistors, i'll probably do that. where should I find the relay for sai? like what number should it be on the block? or would it not be located on the fuseblock? and i'll...
I can try another one but then ill throw codes for the **** my chip is supposed to be deleting unless I switch the chip over too. I'm just confused as to why there are any sai codes being thrown...
List of the codes my bitch threw today...
Injector circuit cylinder 6 short to ground
Secondary air injection circuit short to ground
Maf circuit low input
I kind of figured as much, I was just trying things that were suggested to me.
Correct. There's 4 spots, when my obd1 harness was still in, all 4 plug spaces were taken and the vss was spliced into the one.
Tried new maf, and throttle body already and ecu. Everything else in that list is brand new on my car. And my chip should be deleting the rear o2 (which I don't have plugged in) .
Will def post...
Yea, my obd1 harness had the wire spliced into an existing plug that was in the box. So I did the same with my obd2 harness. Is that wrong?
Yep it is! Just actually found a similar write up to that. Thanks!
Anyone have any suggestions as to why it may be bogging out? Hoping to get the obd2 port wired in after h2o
I have a 91' nugget that was obd1 coilpack motor vr swapped (ran but had its occasional issue). I currently did the obd2 swap. after getting everything swapped over and what I believe to be all the...