Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: DigiMatrix

    Page 1 of 11 1 2 3 4

    Search: Search took 0.40 seconds.

    1. Replies
      4
      Views
      383

      Can you tell me what ECU your car has? I think I...

      Can you tell me what ECU your car has? I think I would start with the following:

      Check the O2 heater is getting + 12 volts
      Check the other heater wire has a good ground
      Check the resistance...
    2. Replies
      4
      Views
      383

      What temperature is the coolant? It is normal...

      What temperature is the coolant? It is normal for the car to run rich and the ECU to be running in "Open Loop" when first starting the car - even if it is warm. If you are saying it will never go...
    3. Yes, I had done so many things to try and resolve...

      Yes, I had done so many things to try and resolve this it makes me sick. I ran a ground wire directly to the same point. I also ran one to sensor ground on the head. My wagon is also black, and it...
    4. An Update: The wife had no issues with the car...

      An Update:

      The wife had no issues with the car today. Even she said it is fixed because there is no way she could have driven with all the starts and stops without it happening today if it wasn't...
    5. Thanks for your input Shawn, time will tell - the...

      Thanks for your input Shawn, time will tell - the wife took the car for a good run today, and if it didn't have any issues then I am convinced this was my issue.

      Too bad you didn't try leaving the...
    6. Shawn, I am bringing this back from the dead. I...

      Shawn, I am bringing this back from the dead. I have had the exact same issue on my G60 Syncro Passat. I have been chasing this issue for a long time, and I think I have finally got to the bottom...
    7. Replies
      9
      Views
      620

      Short answer is yes. But... you really need to...

      Short answer is yes. But... you really need to state the number that is on the eprom for example, I believe the DQ uses the following chip: 1 267 356 637 and is from a Passat Syncro if my...
    8. Replies
      9
      Views
      620

      I think... it is 33 ohms. Based on my...

      I think... it is 33 ohms. Based on my information, that is connected to pin 25/20 which is MIL related. What issues are you having with this ECU? I don't think replacing it will make any...
    9. Replies
      27
      Views
      1,910

      Although this method may work, please be aware,...

      Although this method may work, please be aware, if the crank pulley has a loose keyway, it can cause error in your mark. A better method may be to use a dial indicator on an object touching the...
    10. Replies
      1
      Views
      477

      Here are a couple of things to check: Can you...

      Here are a couple of things to check:

      Can you hear the fuel pump run for 2 seconds when you first turn on the ignition switch?
      If no, check relay #30 at location 3, or ignition switch
      ...
    11. Replies
      27
      Views
      1,910

      Are you sure you can't use the flywheel? Looks...

      Are you sure you can't use the flywheel? Looks like this:
      http://members.shaw.ca/dcstarr/images/Corrado/Timing/TimingMark.JPG

      Note:
      TDC is the "0" just to the right of the red circle
      6* BTDC...
    12. TB Butteryfly = throttle Body butterfly valve...

      TB Butteryfly = throttle Body butterfly valve
      IIRC = if I recall correctly
      ISV = Idle solenoid valve
    13. Look here:...

      Look here:
      http://forums.vwvortex.com/showthread.php?697670-g60-FAQ-Read-this-first!/page2
    14. I agree with you. I made this up: ...

      I agree with you. I made this up:


      http://members.shaw.ca/dcstarr/images/Passat/BBMBoostTubes/Boost%20Tube%20orientationNew.jpg
    15. Thank you for your replies, looks like down is...

      Thank you for your replies, looks like down is the way to go. I have an overhead chain block, so with the pit, it is really the same thing. I agree with you on getting a used engine. I will...
    16. 1999.5 Jetta AEG 2.0L crankshaft replacement opinions

      I would like to get some opinions on the best way to perform the task of replacing the crankshaft in a 1999.5 Jetta 2.0L AEG engine.

      Ok, the story goes that a Junior hockey player we are billeting...
    17. Thread: digi-lag?

      by DigiMatrix
      Replies
      11
      Views
      737

      Why don't you take it to BBM - they are in...

      Why don't you take it to BBM - they are in Portland. Will probably save a lot of frustration. The Digi system is capable if you know what you are doing with it. I know a guy in Germany that is...
    18. Thread: digi-lag?

      by DigiMatrix
      Replies
      11
      Views
      737

      There are 2 WOT timers in the code, one is for an...

      There are 2 WOT timers in the code, one is for an RPM <= 3150 RPM and the other for > 3150 RPM. From everything I have read, I believe this code all has to due with holding the car in closed loop...
    19. Thread: Wtb g60 ecu

      by DigiMatrix
      Replies
      1
      Views
      110

      Wtb g60 ecu

      No longer needed - problem resolved
    20. The relay for the ECU power is in location 3 and...

      The relay for the ECU power is in location 3 and will have either a number 30 or 32 on it. I would try running a jumper wire to bypass it to see if it solves your problem. It is common for these to...
    Results 1 to 20 of 215
    Page 1 of 11 1 2 3 4