Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: CoolAirVw

    Page 1 of 13 1 2 3 4

    Search: Search took 0.85 seconds.

    1. Replies
      4
      Views
      201

      Why two threads??? I'll only be replying in...

      Why two threads???

      I'll only be replying in the other thread.

      Here is the other thread.
      ...
    2. Delayed upshift cold is usually solenoids...

      Delayed upshift cold is usually solenoids sticking.. See the following link.

      http://forums.vwvortex.com/showthread.php?4188370-02-1-8T-Jetta-not-shifting-gears-from-1st-when-cold

      Most likely...
    3. Replies
      4
      Views
      201

      Most likely you have sticky solenoids. See the...

      Most likely you have sticky solenoids. See the following link.

      Read the following..

      http://forums.vwvortex.com/showthread.php?4188370-02-1-8T-Jetta-not-shifting-gears-from-1st-when-cold

      ...
    4. Replies
      9
      Views
      349

      If you got plenty of money and want to pull the...

      If you got plenty of money and want to pull the trans then go ahead.. If I were you I would check the fluid to eliminate the possibility of the whine just being the pump sucking air. (although I...
    5. Here's a link to some Tiguan trans types. Its...

      Here's a link to some Tiguan trans types. Its not clear which you would have.. Having the engine size would help, but might not be all the info.
      ...
    6. Replies
      25
      Views
      679

      Make sure your diff is full of oil.

      Make sure your diff is full of oil.
    7. Replies
      10
      Views
      362

      That VB kit doesn't do anything but give you...

      That VB kit doesn't do anything but give you instructions and parts to attempt repair on the solenoids. I've experimented with it, and there are better ways to deal with the solenoids than that kit....
    8. Its very difficult to access the trans case...

      Its very difficult to access the trans case connnector to ohm check. Even if you disassemble stuff your trying to poke your multimeter leads into the connector, which is still hard to get to and you...
    9. Replies
      9
      Views
      349

      Make sure to check the fluid.

      Make sure to check the fluid.
    10. Replies
      25
      Views
      679

      I have some that I've acquired when converting to...

      I have some that I've acquired when converting to a 5 speed.
    11. I agree with GSferrano ... your probably low. ...

      I agree with GSferrano ... your probably low.

      Did you check fluid level with engine on or off?
    12. Replies
      25
      Views
      679

      Disconnect the exhaust. The motor will need to...

      Disconnect the exhaust. The motor will need to flex forward to clear the "k member"(k memeber is the part the lower control arms and rack and pinion bolt to).

      Using a stand under the engine makes...
    13. solenoid can stick and cause no reverse. There...

      solenoid can stick and cause no reverse. There are two designs of solenoids in 09a. Both have sticking problems.

      Most common is no reverse and no upshift (usually worse cold) but almost any...
    14. probably didn't need the g68... Probably just...

      probably didn't need the g68... Probably just needed solenoids all along

      read the following link.
      ...
    15. Replies
      4
      Views
      352

      01 passat would have 01v (zf5hp19) trans

      01 passat would have 01v (zf5hp19) trans
    16. Replies
      14
      Views
      3,644

      I have fixed several. Note: vr6 only.... ...

      I have fixed several.

      Note: vr6 only.... and it could have a problem in the trans, as well as the "defective" tcm causing 2-3 flare, so you absolutely could change the tcm and still have the...
    17. Here's some info you would need to know to...

      Here's some info you would need to know to interchange..

      http://forums.tdiclub.com/showthread.php?t=266472
    18. taking the axle stub out is a good method for...

      taking the axle stub out is a good method for manuals but not such a good method on auto (assuming 01m) as there is a rubber sealed cup plug that you have to destroy to get the axle stub out.
      ...
    19. Replies
      4
      Views
      365

      chances are good you need a trans but there is...

      chances are good you need a trans but there is one problem that makes a similar situation in the VB. Good chance that would be a waste of money though.
    20. Common problem. I usually tell folks to live...

      Common problem. I usually tell folks to live with it as long as you can. When it gets so bad that you have to give it some gas to make it 'bump" into gear then you need to start budgeting for a...
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4