Type: Posts; User: MaxVW
Full c2 kit
will trade for OBD1 coilpack
ok thought i would just toss that out there
sick build cant wait to see it done!
Hey I am thinking it is possible the factory coolant pump isn't quite up to the task. I converted my golf to rwd and having the engine the other way the coolent hoses to the rad are so long and they...
it should sit great. a 15x6.5 et -6 sits the same as a 15x8 with an et of 10
thanks guys. anyone know the best place to buy 30-40 mm spacers?
I have this photo of my only pass this is it launching for the first time
Turns out my...
still have this?
thanks everyone I cant wait to get it all finished up and have this looking and functioning 100%
I forgot to mention I owe a big thanks to my buddy Matt, you help was critical in getting this...
Sorry for the slow update. the car runs and drives! its not finished yet but hey its a RWD golf that works. I made 1 pass at thunder in the valley on smart car tires. it wasn't awesome (2.3 sec 60...
My thred from Dubberz
So everyone thinks Im nuts but i decided to do it anyways..
I measured up a 325 and found it is really not far off from a golf in terms of wheelbase and track width....
haha i haven't even posed these pics on dubberz yet. I need to finish that build thred and well finish the car too. it does run and drive. gets sideways really well. it does had some driveshaft...
just a t3t4 .63 ar needs some fat rubber in the rear now ;)
does anyone know what happened to this? the user hasnt been active for many years
it has been done before, you can only do it with CIS though
LOL, vrt's are not expensive. I would be willing to bet it is one of the best hp/$ engines
if you are craft you could have a VRT for 2 grand and be making more then 300 whp
VRT = Fast and easy,...
I know there isn't much point in mentioning this but the pilot bearing isn't used in vw's transverse engine layouts. if you look at the input shaft on the transmission it wont reach it not fit in the...
I have a t3 housing that is cracked. apparently it is normal for them to crack over time. I have had a crack on the inside of my turbine housing for many years. dosen't seem to matter
looks pretty legit to me. usually fakes don't have Garret on them. if its just a housing i wouldn't worry anyways, I have used ebay cheap crap housings and they are fine.
IIRC If you use a 1.8 cl headgasket the hole is blocked by the head gasket itself. I used a victor rienz head gasket and a bit of silicone around the area upon head install and I never had any oil...