No response from above.
Type: Posts; User: silentdub
No response from above.
Well.... LED should least for almost ever.... it is the electronics that they add to them that fail.
I'll probably get these though, I like the style.
Looking for a pair of Axle Flanges for a 02A/VR6.
Located in Newark DE, USA.
Do you still have the pair?
Still have the flanges for the 02A? If so, PM me. Don't need the shafts.
Thanks. I'm happy with my OEM but I'm not putting it back broke. I do like these but don't want to see the LEDs burn out right away and I'm F'd. The LED never actually fails it's the electronic...
Does anyone have any experience with these? My one light is cracked and finished breaking when I removed it for paint prep so needless to say I need a new one. I am not in to the Altezza style but...
Thanks, I'm checking these out now. I like the idea and look of real glass.
Should I assume that any of the 'projector' type are all NON-Halogen Bulbs and require HID, LED etc...? Is that a...
I also like the halos too.
My headlight units are beat after 240K miles, since I am getting new paint, I am going to replace the lights as well. Do any of the aftermarket styles come with 'real' glass?
Is it only under acceleration? at 80 while in Neutral?
I've always found shaking at high speeds is usually caused by Tires/Balancing/Alignment
1. Don't touch the glass with your hands, use gloves.
2. Low voltage will cause premature failure.
It CAN be turned off. That, The Seat Belt Chime, Light.....
Need VAG-COM and you can kill all that nonsense.
Okay. They did a compression test on all cylinders, if so, what are the readings?
If there is a loss of compression in CYL 5, I would suspect a possible head gasket or valve maybe.
WOAH!!! That is some list from a car that was clean a week prior. I am betting you've lost power somewhere, I can't see all them sensors being bad. There is a loss of power, bad connection or...
Good Job! I was starting to think you had a gremlin in that thing.
Belt Dressing doesn't work, just hides the noise for a little while.
Not sure what belt I used but I went OEM from GAP at the...
The housing has two ports, one for an additional sensor, the plug takes the place of the sensor.
When I opened up my cooling system, I replaced everything.
The o-rings on the oil cooler will...
If oil and water are mixing, your dipstick will look like dirty milk and not like oil. Check that first.
The oil coolers I've heard from some saying they fail but I have yet to see one fail where...
1. Check the plugs, that motor will only run properly using the factory correct double platinum spark plugs, they are expensive and the only ones that will last more than 2k miles.
2. Spray the coil...