Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: Mr.loops

    Page 1 of 13 1 2 3 4

    Search: Search took 0.49 seconds.

    1. Another solution is to build the pitted area up...

      Another solution is to build the pitted area up with JB Weld, then as Stefan suggested, use silicone as added insurance

      Torque specs are important here as well. Too tight, you run the risk of...
    2. Replies
      2
      Views
      137

      Thats it! I've seen two different style...

      Thats it!

      I've seen two different style plates. One bolt hole with a hook ( pictured) and the other, two holes and no hook

      I believe they are interchangeable
    3. Thread: 020 problems

      by Mr.loops
      Replies
      2
      Views
      157

      Did you order/install the correct PP for your...

      Did you order/install the correct PP for your car? Remember there are two different styles - one pin vs. two pin
    4. Replies
      3
      Views
      148

      1) No you'll be fine. Its just a guide/support...

      1) No you'll be fine. Its just a guide/support for the selector

      2)From the factory, there is no gasket or o-ring used. I've used HondaBond ( or any Silicone liquid gasket) to seal this area up...
    5. Replies
      7
      Views
      134

      I still have all gears the go onto the input...

      I still have all gears the go onto the input shaft as well :)


      Sent from my iPhone using Tapatalk
    6. Replies
      7
      Views
      134

      I have one...

      I have one
      http://images.tapatalk-cdn.com/15/07/21/e5e8f8687ba5bf76c7d3890c3516a247.jpg
      Teeth count: 9 and 17



      Sent from my iPhone using Tapatalk
    7. Put the key in the drivers side door then connect...

      Put the key in the drivers side door then connect the battery

      When the alarm sounds, turn the key to disarm


      Sent from my iPhone using Tapatalk
    8. Thread: Wtb: Vr icm

      by Mr.loops
      Replies
      1
      Views
      49

      191 905 351 B ? I have several I working...

      191 905 351 B ?

      I have several I working condition

      $30.00 shipped


      Sent from my iPhone using Tapatalk
    9. Looking at the photo, it looks like you can...

      Looking at the photo, it looks like you can re-attached the wire with a simple butt connector and get the car home.

      Down the road, I would use a non-insulated butt connector, shrink wrap, and...
    10. First, I would confirm that your shift linkage is...

      First, I would confirm that your shift linkage is setup properly. After doing that, I would check to see if the manual clutch cable has been set up for the correct amount of "pull"

      After doing...
    11. Replies
      4
      Views
      219

      Bummer you got burned If you can, next time do...

      Bummer you got burned

      If you can, next time do your transactions via PayPal

      Your covered by PP and bad sellers get their accounts closed


      Sent from my iPhone using Tapatalk
    12. Replies
      1
      Views
      72

      I have a few harnesses at PNP I could grab one ...

      I have a few harnesses at PNP I could grab one

      Do you have a manual or auto?

      A/C?


      Sent from my iPhone using Tapatalk
    13. Replies
      2
      Views
      199

      If your Jetta is a 2 litre you'll be good to go....

      If your Jetta is a 2 litre you'll be good to go.

      Keep in mind though, the seller has 90mm drive flanges on that transmission. Yours should have 100 mm - no biggy, you can just swap them over (...
    14. Replies
      2
      Views
      89

      Is this an auto or manual? Sent from my...

      Is this an auto or manual?


      Sent from my iPhone using Tapatalk
    15. Replies
      5
      Views
      268

      If you can, get that car scanned for codes - stop...

      If you can, get that car scanned for codes - stop tossing parts at it :(


      Sent from my iPhone using Tapatalk
    16. Thread: 020 Internals

      by Mr.loops
      Replies
      3
      Views
      216

      Ask Broke himself. He'll sell you everything...

      Ask Broke himself. He'll sell you everything you'll need

      I bought a brand new ( Chinese VW) reverse idler and gear from him last year. It seems to be functioning just fine :)


      Sent from my...
    17. Replies
      19
      Views
      459

      The driver and passenger side door switch's are...

      The driver and passenger side door switch's are joined together (red/blk) before it enters T10/6 of the alarm module. I would check for any shorts on this circuit.
    18. Replies
      6
      Views
      1,376

      The CHC came out of 92-96 Golfs/Ventos, and 95-96...

      The CHC came out of 92-96 Golfs/Ventos, and 95-96 Polo's

      Here are the ratio's:

      3.667 N/A 3.455 1.944 1.286 0.909 0.745
    19. Paul, I would like to be added to the list

      Paul,

      I would like to be added to the list
    20. Replies
      6
      Views
      493

      Picked up one more. Out of a 97 TDi

      Picked up one more. Out of a 97 TDi
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4