I have one
Type: Posts; User: Sparknock
I have one
starter if the car is a stick? shipped to 29907?
this got my car running!!!!
wideband is a must
an other bit of info. if you want a 35/40 and find a 40 with a trashed compressor wheel you can get the compressor wheel from a HE351cw or VE. it's the same as the 40's in a 7 blade config.
It will be a bit before the car is running still waiting for mt exhaust manifold to be fixed.
Stupid me bought one of the bbm 16v mani's and down pipes. The head flange was way to thin. It,kept ...
I got the cluster finish.
here is the finished product
your car is odb1 95.5 is the start of odb2. you need a vag com to check it out.
if you have an auto parts store scanner then it wont work its looking for j1968 or something like that.
being a 94...
what part of 95 was it built? what im getting at is it odb1 or 2?
the biggest thing for me with a stand alone would be ease of use.
next would support. what good would it do you if you can't get the motor to run. MS is simple and there are a ton of people that use...
I have seen this asked a bunch of times.
"how do I use the G28 VR engine speed sensor with my stand alone "
I hope this answers the question.
to start off most VR sensors are 2 wires. The...
temp issue fixed
still need to know how to wire g28 sensor
I think the holset would drop right in. the drain is the same you just need an adapter for the feed line.
well does the PTE 6262 have a 4" inlet? that maybe the only difference.
I am wiring up my MS. I got the TPS, ECT, and IAT wired up.
I stopped to check and make sure I wired things correctly. its was about 65 degrees in the shop. my IAT, and ECT where only reading 17...
the HX40 will support 650 HP. my turbo has a 2.5 inch compressor discharge. the turbine housing is a T3 T31 and you can get a v-band housing from BEP in .55 a/r and .70 a/r. the tims turbo housing is...
Holset hx35 with a tims turbo exhaust housing.. or the hx40
I really dislike Garrett turbos. holsets are made to be over worked and under paid. they spool faster than an alike Garrett. oh they cost...
I could have used ABS plastic but i messed up 3 time wood was free the plastic was not. The router cuts abs just fine.
So sense I am rewiring my 16vT with a stand alone I thought I would add some jazz to the cluster.
This is what I made
I have to cut the rear of the cluster shroud with my table saw to make it...
This turbo has been sold