Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: madonion

    Page 1 of 13 1 2 3 4

    Search: Search took 0.65 seconds.

    1. I hope you guys realize this is a temporary fix....

      I hope you guys realize this is a temporary fix. it's caused by the bearing spinning it's outside edge in the aluminum transmission casing. It's a serious design flaw. You can fix it in a way that...
    2. Thread: EGR

      by madonion
      Replies
      1
      Views
      248

      Apparently the combi valve isn't considered an...

      Apparently the combi valve isn't considered an EGR device in the Bentley manual.
    3. Thread: EGR

      by madonion
      Replies
      1
      Views
      248

      EGR

      Will the EGR work even if the rest of the of the emission stuff is deleted ? Evap and secondary air injection pump system is deleted also second O2 sensor is deleted ?
    4. Replies
      0
      Views
      242

      Ticking sound video please help diagnose

      Here are videos I shot today. Let me know what you think it is. It's getting picked up by the knock sensor.




      https://www.youtube.com/watch?v=AWX-9iTzzoU&list=UUFMeCXNm8RWb8rvr9qGNDlw&index=3...
    5. Replies
      1
      Views
      205

      http://forums.vwvortex.com/showthread.php?6032449-...

      http://forums.vwvortex.com/showthread.php?6032449-02m-input-shaft-back-and-forth-play&highlight=02m+input+shaft+play...
    6. Is there a way to test for a bad wrist pin ?

      Is there a way to test for a bad wrist pin ?
    7. Replies
      5
      Views
      409

      Yes you can but you will most likely regret it....

      Yes you can but you will most likely regret it. When I did my swap I didn't have one. I have a single mass flywheel and my clutch disk doesn't have springs. This piece allows you to slowly release...
    8. Replies
      5
      Views
      621

      If you don't have any issues don't change.

      If you don't have any issues don't change.
    9. Replies
      2
      Views
      347

      Timing chain tensioner

      How can I tell if a timing chain tensioner is good or bad ? Mine doesn't seem to operate smoothly it's making a noise like if the piston was binding and hitting the side of the cylinder as is goes...
    10. Replies
      14
      Views
      2,038

      91 it's octane that's all I can get here. I've...

      91 it's octane that's all I can get here. I've gone trough a few gas tanks without much change.
    11. Replies
      14
      Views
      2,038

      I took the compression with a warm engine and...

      I took the compression with a warm engine and everything seemed good . Every cylinders was in the 165 range dry and 180 wet. I've changed the spark plugs to NGK BKR7E to see if it would help with the...
    12. Replies
      0
      Views
      443

      Chain noise detected by knock sensor ?

      If I had a broken chain guide or malfunctioning chain tensioner could the knocks sensors sense chain noise as knock and retard the timing ? I'm trying to find out if the noise I have is really...
    13. Replies
      14
      Views
      2,038

      I did a cold compression test tonight ... 140...

      I did a cold compression test tonight ...

      140 142 130 65 132 147

      number 4 is abnormally low I will do a leak down test tomorrow night.
    14. Replies
      14
      Views
      2,038

      I went for a drive today here is a sample of the...

      I went for a drive today here is a sample of the log. The pinging is just horrible. I swapped the engine in the corrado by my self It never ran right it always had the pinging going on. Was around...
    15. Replies
      9,844
      Views
      454,707

      stock fuel pump flow

      I was wondering if anyone knows how much WHP can the stock dual fuel pumps setup from a 1990 g60 can support ?
    16. Replies
      9,844
      Views
      454,707

      hard start fuel check valve ?

      I have a issues starting the car after it sits one week in the garage. I need to prime the system a couple a times for it to start and give it gas to prevent it from stalling when it first start. The...
    17. Replies
      0
      Views
      419

      Leak detection pump open circuit swap

      I've got that code and fuel trims aren't adapting with my vr6 24v swapped into a corrado 1990. Is there a way to fake the presence of the leak detection pump with a resistor or does the computer need...
    18. Replies
      14
      Views
      2,038

      Is block 32 a real time value ? or a learned...

      Is block 32 a real time value ? or a learned value. Because I always see 0.0% there it never change. I haven't done test it while on the road. I haven't disconnected recently.
    19. After looking at some diagrams the following...

      After looking at some diagrams the following gasket was missing and I found the part looking trough my stuff :

      357721410

      I think I might have resolved my problem. I'll take the car out for a...
    20. Difference between g60 clutch master cylinder and vr6 one ?

      It's an unsprung Disc sadly. But i'm most concerned about pedal height than harshness of engagement. I'll try to find a used one.
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4