Username or Email Address
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    VWVortex


    Search:

    Type: Posts; User: ArsenicPants

    Page 1 of 13 1 2 3 4

    Search: Search took 0.67 seconds.

    1. Bump for Mikey. The red emblem mast0r

      Bump for Mikey. The red emblem mast0r
    2. Also in for the list, but I'm very interested in...

      Also in for the list, but I'm very interested in that early Audi petri scirocco-style wheel.
      Would you ship it to Washington?
    3. Ships from pocompton?

      Ships from pocompton?
    4. Replies
      4
      Views
      213

      This isn't a radio delete plate. Its a center...

      This isn't a radio delete plate. Its a center console gauge delete plate. They put them on lower-end models
    5. I didn't say it went from a negative ground to a...

      I didn't say it went from a negative ground to a positive ground. I converted the wiring to use a standard relay to switch power on with the ground, as opposed to switch ground on with power. I've...
    6. never mind i remembered I had an old broken...

      never mind

      i remembered I had an old broken fuse box and took it apart to track the circuit. the ground for the relay is at K8, which pins out at C5 and D11 on the back side of the fuse box.
      ...
    7. thanks for the help, although I should have...

      thanks for the help, although I should have mentioned I replaced the ignition switch with a brand new one.
      also, the fuel pump is working on a switched power, as opposed to a switched ground,...
    8. Early fuse box load reduction relay ground

      I'm dealing with an issue in my '81 jetta with an early style fuse box. When the key is in and turned to the accessory (just before cranking) position, The load reduction relay clicks over and over...
    9. source for NOS or new replacement OEM quality early fuse box?

      I'm in need of a new fuse box for my '81 Jetta, and it uses the early bullet / pill box type fuse box.
      I took my old one apart, down to each layer, and cleaned every piece. I found that the piece...
    10. Replies
      10
      Views
      739

      Master cylinder from a non-abs coraddo or non-abs...

      Master cylinder from a non-abs coraddo or non-abs Audi 5000 turbo will be fine. Both those cars use the beefier girling 60 twin piston calipers and have a bigger master to go with them
    11. Replies
      3
      Views
      743

      First time user ms1 v3 questions

      I've posted this on the msextra forums as well, but since their ms1 forum activity is pretty lackluster, I figure I'll try my luck here, too

      I'm brand new to megasquirt, and I just picked up a...
    12. Replies
      3
      Views
      209

      A 9A with ABA serpentine pullies

      A 9A with ABA serpentine pullies
    13. Replies
      3
      Views
      209

      Wtb: 60-2 trigger wheel & hardware

      I'm looking for a 60-2 trigger wheel setup, including a bracket to hold a VR sensor in place.
      Must be for a serpentine-type crank pulley, and preferably one that sandwiches between the crank and...
    14. http://photos-g.ak.instagram.com/hphotos-ak-xfa1/t...

      http://photos-g.ak.instagram.com/hphotos-ak-xfa1/t51.2885-15/10843820_385130154996158_177176511_n.jpg
      ...
    15. Replies
      1,157
      Views
      132,243

      Dubahol's car! He's local to me. That car has...

      Dubahol's car! He's local to me. That car has been in the works for years, but its all been worth it.
    16. It is.

      It is.
    17. I did the same conversion on my jetta, and just...

      I did the same conversion on my jetta, and just put the rubber accordion plugs back in from the adjusters. it's not perfect, but it's better than a big gaping hole. i've just been on the lookout for...
    18. I drove a turbodiesel jetta for a long time and...

      I drove a turbodiesel jetta for a long time and wasn't able to go over 100ish km/h, which us about 60 mph. I never figured out what the problem was. I cranked up the fuel mixture, ran it off a...
    19. Replies
      41
      Views
      3,134

      Aaah, ok. Ya, I guess the plenum IS a little...

      Aaah, ok. Ya, I guess the plenum IS a little bigger. Do you have any numbers to show that it's a better manifold?
      I guess the idea is slightly higher horsepower with a little less torque at higher...
    20. Replies
      41
      Views
      3,134

      Can you tell me more about the modified intake...

      Can you tell me more about the modified intake manifold? It looks like it has the same dimensions as a standard euro 16v intake; same runner length, same plenum size. Or am I wrong?
    Results 1 to 20 of 250
    Page 1 of 13 1 2 3 4