grab the front (from the sides) at both ends and pull up... it will take a little force so don'e be alarmed. Repeat at the rear... Just a bunch of rubber grommets.I think it's easier to line the front up first when putting it back on.
Make sure all the grommets are in place before you replace.
+ Reply to Thread
Results 1 to 3 of 3
Thread: Engine Cover removal?
-
Member
- Join Date
- Nov 10th, 2002
- Location
- NJ
- Posts
- 1,629
- Vehicles
- 04 W8 6spd Wagon
Engine Cover removal?
10-26-2003 07:54 PM
#1
Ok, I know it's a newbe question, but, I can't seem to figure out how to remove the engine cover? I just want to remove it and look underneath it. Are there bolts, Screw, clips? And where are they located? Thanks.
-AJ
Originally Posted by rconn14:
The fact that someone invented a system that saves you the struggle of turning your head to check your blind spot, yet there is no dash-light that says "get your ass out of the left lane you cell phone wielding ****"
-
-
Member
- Join Date
- Oct 16th, 2002
- Posts
- 2,547
Re: Engine Cover removal? (AJB)
10-26-2003 07:59 PM
#2
-
Member
- Join Date
- Nov 10th, 2002
- Location
- NJ
- Posts
- 1,629
- Vehicles
- 04 W8 6spd Wagon
Re: Engine Cover removal? (BadassVW)
10-27-2003 08:30 AM
#3
Thanks alot! Being a new car and all, I didn't want to break it, so I wasn't pulling on it hard enough.
-AJ
Originally Posted by rconn14:
The fact that someone invented a system that saves you the struggle of turning your head to check your blind spot, yet there is no dash-light that says "get your ass out of the left lane you cell phone wielding ****"
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
For advertising information click HERE
