Official MS Roll Call and Discussion Thread

[JackJoachim]

Really considering going Stage 1, APR has a dealer like 50 miles from here. Sounds like a fun road trip.

[goscha7452]

Really considering going Stage 1, APR has a dealer like 50 miles from here. Sounds like a fun road trip.

You wanna buy a 42dd 3" down pipe for cheap

[Jon Coulson]

Hey guys my corrado is for sale if y'all know anyone looking for a fun car 4k.

[goscha7452]

Hey guys my corrado is for sale if y'all know anyone looking for a fun car 4k.

I'm done with VW man. Luckily we never made that trade a few months ago because the car crapped out last weekend. If you know anybody trying to take a mk4 into the 300-400 whp range let me know

[JackJoachim]

I'm done with VW man. Luckily we never made that trade a few months ago because the car crapped out last weekend. If you know anybody trying to take a mk4 into the 300-400 whp range let me know

Whaa? What do you mean your done? What are you going to next? What happen to the golf?

[goscha7452]

Whaa? What do you mean your done? What are you going to next? What happen to the golf?

I'm going to this

[JackJoachim]

Lower it. and get some RS

[goscha7452]

Lower it. and get some RS

I like it the way it is. Gonna have some pros swap the motor though. This one has the little 289ci. I'm thinking a 351,390 or 429 is in store. Just depends what I want to spend.

[JackJoachim]

I like it the way it is. Gonna have some pros swap the motor though. This one has the little 289ci. I'm thinking a 351,390 or 429 is in store. Just depends what I want to spend.

Wait your serious? I thought you were just joking what happen to the Evo 9?

[goscha7452]

Wait your serious? I thought you were just joking what happen to the Evo 9?

I'm dead serious. I've already sold my turbo kit to a guy in Florida. My dad went ahead and bought the Fairlane from a guy in Georgia and I'm going this weekend to pick it up and pay dad back. Couldn't pass up a classic for $13k even with an Evo close by.

[JackJoachim]

So how much do you want for you scanner?

[goscha7452]

$50. I don't even remember what I paid for it.

[noodlesdefyyou]

hey guys. still needing some help with my proportioning valve. the 2 aluminum screws holding it to the frame are corroded, and currently the only way i can think of removing the valve is to either drill the screws out (and i dont know where to even begin looking to find replacement screws) or cut them off the frame, causing the new valve not to have any frame to remount to (and then theres the screw issue again)

anyone willin to help take a look and figure this out? ive got the new valve and a replacement line for what i need, just cant figure out how to remove the old valve.