SOLD - sad to say
The 4 molds for the fenders flares are available. $1500.
Full prep SCCA F-Production 1983 GTI 1850lbs / 190 HP on dyno. Track record holder at NHIS, 7 time NERRC and NARRC champion, best of everything. asking $11,000. MOTIVATED SELLER...MAKE AN OFFER!!! OVER $40,000 invested!
Molds for hand made fenders can be included or sold outright.
1min13.6sec at NHMS / 1min1sec Limerock (with an old man driving!)
September 11 " 9-11" Victory Lap at NHIS
* ALSO FOR SALE: (ONLY 1 SET.)
A1 A2 W*I*D*E
A1 A2 W*I*D*E NEW FENDER FLARES for Race, Street or Show $795.00
See Post Below!!!
NEED A TOW VEHICLE? SEE POST BELOW:
re: F-production VW GTI Rabbit with about 100 first place wins in both regional and national race meetings. (also eligible for Vintage SCCA)
I'm not sure where to start...I'm bearing down on 60 years old...time to let someone else win. The suspension is hand built all spherical bearings(no rubber bushings), springs dialed in with Bilstein coil overs, triangulated rear axle. On board halon fire system, 8 gal ATL fuel cell, Kirkey seat with glass hood, tailgate and lexan windows. Car weighs in at 1800 lbs. The engine was built by Shine Racing 190+ HP on the dyno, forged pistons and rods. Cyl head by Rick's Engineering, 16 qt Dry sump oil system, Canton-Mecca accusump, hand made intake manifold with dual side draft 45 DCOE Webers, hand made vortex aluminum induction and hand built alum dry sump pan by Moroso. Wheels are 13 lbs with Hoosier 23x10x15 slicks.