Last edited by baun; 04-26-2012 at 06:43 PM.
HS TUNINGLOWERED EXPECTATIONS
My build thread
I bet with some polished lines, remote fuel filter, clean routing for a front mount and a few other odds and ends it would be an amazing bay...
got the gears turning now lol
Software coding is the only way to be truly code free, as well as running the proper resistors since you still need to complete the circuit, this will keep your fuel trims. well at least on my 1.8t it does. not quite sure about the new motronic ECU's but im assuming its the same.
Heres a pic of my bay for the thread, it wont look like this for too much longer tho
Last edited by ascgti89; 04-28-2012 at 12:52 AM.
on another note: for the fuse box relocation: crimp or solder?
what works better?
dont pull out. your dad didnt
Body Filler ????
What are you guys using? Just regular bondo, or something with fiberglass in it?? I also noticed many dont fill the body lines where the seam sealer was What do you use for the seams, or is nothing used?
Where my progress ended last night(obviously still need more sanding)
I use rage gold after welding and working the metal as close as possible. then USC icing as the topcoat for finishing off before primer. if you are not welding the seams solid and getting rid of them, you need to re-seam seal them so moisture doesnt get in between the panels causing rust.