WTB: Syncro Passat disc brake dust shields
Quote, originally posted by Sleeper-Dub » Looking for passat syncro rear subframe mount brackets
if its just the two brackets that go in the front mounts of the rear frame. I have a pair that are powdercoated.
Do you still have the rear diffenertial and coupler? Even though the coupler is shot I would like to have it. As far as I can tell the Mk2 and B3 use the same gear set in the rear differential, so it should work in my Passat.
I'm looking for the two flanges that the propshaft mounts to (front and rear). The back one looks like this (the 3 mounting point one perpendicular to the drive axels). I threw another propshaft and bent these in the process.
I have available a working syncro setup
Perfect for your MKI MKII MKIII AWD conversion!!
VR6 syncro bell housing for an additional $400
02C Gearbox with gearshift housing
02C angle Drive
02C rear differential
rear sub frame & swing arms
rear knuckles, spindles, rotors and calipers
Sub-frame and other chassis parts have some surface rust and should be disassembled, media blasted and painted or coated if you want them perfect.
The carrier bearings are of course shot on the prop shaft.
Rotors and such should be replaced, but are there.
The trans, angle drive and rear differential are mileage unknown however mechanically perfect.
Ill post pics later this week, the parts are in storage for the moment.
Will install LSD front and or rear if desired for an additional fee.
$975 picked up
will not ship, sorry.
Deposit taken, sale pending on swap and vr6 bell
Will update when sale is complete
Modified by Technik Motorsport at 2:51 PM 4-15-2010
Modified by Technik Motorsport at 5:12 PM 4-24-2010
FS - 08 R32 front transfer assembly. 13K miles. $600
Transmission also available, shipping is not (for the transmission). Trans was ran out of oil - $200 picked up. I've got extra clutches for it as well.
WTB rear subframe mounts for a syncro passat subframe. And the syncro swap is going into a mk2 GTI so i dont know if there are different mounts or not. But I need something asap if someone can help me please i have cash and want and need these parts guys so i appreciate the help.
I have a clutch housing up for grabs.
I swapped it off of a working syncro gearbox that was slated for a VR6 installation.
So, Here it is - one 4 cyl 02C clutch housing.
150 picked up or - plus shipping takes it.
Ill Clean it up and take new pictures afterward.
FS 4 Motion Controller complete with modded Haldex box, control unit, display, and cables. I bought this from Carbide but over three years ago. I never intalled it because the car isnt finished yet, but Ive decided to go a different direction. $1000 plus shipping. email at email@example.com