Bought a new deck for it, and admired it for around 30 minutes
![]()
#2906
Chopped 3 inches off the shifter and put on an old school wooden MOMO shifter knob.
I wouldnt hurt a fly. Unless it kept buzzing around in my face, and annoying me.
#2907
Bought a new deck for it, and admired it for around 30 minutes
![]()
#2908
Pulled the instrument cluster (again!) yesterday, and got the speedo cables & counter box out.
Still need to tear the cluster apart (again!), lube the odometer shaft (100,000 wheel is dragging on the shaft), and install the new 1pc. speedo cable. And, of course, put the car back together...
Such a stupid reason to not be able to drive the car, having the screeching speedo cable...
- Cup
'88 Scirocco 16v, 'tastefully' modified.
things currently broken (Scirocco): 3
things currently broken (QSW): too many; but, slowly getting better
#2909
Made the driveshafts work, now they can turn without going trapped because of the 2mm smaller wheel bearing housings...had to trick a little bit...
Did some other detail work on the motor and for my motivation I have done this...
By daywalker823 at 2012-04-17
More and more the concept of the car is coming through...![]()
#2910
I'm doing a brake fluid changed replacing the horn and repairing the reverse light switch
sent from rocco 4G
scIROCco 16v / quattro sport *VOLKSHORE/A dutty dub*
- ANYTHING UNATEMPTED REMAINS IMPOSSIBLE
#2911
Well, I got the instrument cluster & speedo cable back in on Monday.
Drove Tuesday, all seemed ok, but for a slight ticking noise (cable routing?)
Oh, and: the damned 100,000 wheel is still turning on its own...
Last night, all hell broke loose.... Speedo screeched real quick, then died. Then it started working again when I came off the freeway.
And, now it's erratic as hell, and noisey as hell at all speeds.![]()
![]()
Time to tear into it again.... Thinking "replace engine ground cable", and "tweak cable routing."
- Cup
'88 Scirocco 16v, 'tastefully' modified.
things currently broken (Scirocco): 3
things currently broken (QSW): too many; but, slowly getting better
#2913
I finally got the 87 16V out of the garage after 5 yrs. New battery, alternator, changed the oil and
coolant. Put the BBS RM's on and went to get her inspected. Passed emission and safety with flying colors.
Been driving her to work all this week. What a BLAST!
Now to get the 88 back on the road!!!!!
#2914
Since my daughter's birth in Dec. my poor Scirocco has been sitting dejected and neglected in the garage. It was such a beautiful day for a drive so I treated her to some fresh Redline, a bottle of Techtron a tank of Sunoco Ultra 93 and a tire rotation.
![]()
#2915
Made & installed a new engine ground cable.
The speedo is, ah, less funky now; but, it's definitely frakked. Needs to order a new one....![]()
(but, they're only $70!)
- Cup
'88 Scirocco 16v, 'tastefully' modified.
things currently broken (Scirocco): 3
things currently broken (QSW): too many; but, slowly getting better
#2916
i actually visited my 'rocco last night. and even pulled back the tarp far enough to open the hatch and crawl inside... the tarp was a good call, as i had expected a good bit of mustiness and moisture evidence, but thankfully none was to be found!
...sadly the engine leveler i was looking for was also nowhere to be found but it was nice to visit nonetheless
damn i miss that car...
#2917
Nothing, car in deep storage waiting till I forgot I have it then bring it out of it's time capsule
cheers,
yarrow
#2918
Drove thd hell out of it on this nice sunny day.......Damn these cars are fun.
#2919
Upside down ABA/JH/MSnS build:http://forums.vwvortex.com/showthread.php?3322625
Frankenturbo: http://forums.vwvortex.com/zerothread?id=4102588
Magical Mystery Tour: http://forums.vwvortex.com/showthrea...l+Mystery+Tour
Cincy'11http://s1092.photobucket.com/albums/...b/Cincy%202011
#2920
#2921
rinsed the pollen off...I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN I HATE POLLEN![]()
#2922
- Replaced the collapsed right engine mount. This one, I filled the top three cavities with urethane before installation.Should hold up a lot better than the last one did (I hope...)
(And, damn!!! is that a pain in the arse of a job. Been dreading it since I found it broken last October.)
Tearing into it, found that she shredded her front mount (not surprising.) Boss was cool, and let me send our shuttle driver up to Parts Place to grab one for me.
- Rotate & balance.
- Brake fluid change.
Ohhhh.... car is soooo much smoother now. I do like the feeling of fresh engine mounts - they vibrate so much less. I missed that feeling.
Oh, and: it "fixed" the mystery rattle from the heater box. Yays!![]()
- Cup
'88 Scirocco 16v, 'tastefully' modified.
things currently broken (Scirocco): 3
things currently broken (QSW): too many; but, slowly getting better
#2923
Drove it!![]()
Upside down ABA/JH/MSnS build:http://forums.vwvortex.com/showthread.php?3322625
Frankenturbo: http://forums.vwvortex.com/zerothread?id=4102588
Magical Mystery Tour: http://forums.vwvortex.com/showthrea...l+Mystery+Tour
Cincy'11http://s1092.photobucket.com/albums/...b/Cincy%202011
#2924
Drove it like I stole it hahaaaa ooh plus I'm replacing the manual clutch cable / 1 horn / oil pressure switch for now.
sent from rocco 4G
scIROCco 16v / quattro sport *VOLKSHORE/A dutty dub*
- ANYTHING UNATEMPTED REMAINS IMPOSSIBLE
#2925
Old sciroccos never die....they just go faster....sometimes.......
www.ziggituning.com
My Project...
#2926
scIROCco 16v / quattro sport *VOLKSHORE/A dutty dub*
- ANYTHING UNATEMPTED REMAINS IMPOSSIBLE
#2927
found this when pulling up the carpet up
new project for the day
#2928
That sucks....![]()
Today:
- oil change
- trans oil change
- replaced windshield wash hose.
#1, was time.
#2... well, after 15 minutes of carefully walking the drain plug loose with an air hammer (damn, that was just a little stressful...) Two new plugs (BMW man trans plugs are a perfect replacement, have 17mm external hex, and cost me all of $3.50 each!), and 2 quarts of Syncromesh.... damn, it's like a new trans. The cold 1-2 shift is so nice now...
![]()
#3, glad I did it now. One of the hoses was starting to crack at the nozzle, [i]and[i] the tee was cracked. Nice little failure-in-waiting there (which, of course, would have happened when it was needed most, right?)
- Cup
'88 Scirocco 16v, 'tastefully' modified.
things currently broken (Scirocco): 3
things currently broken (QSW): too many; but, slowly getting better
#2929
Yesterday did the full clay bar rub down, polish, interior and engine shampoo. Feels like new for now. In fact the body feels like butter to the touch.
#2930
yesterday washed my 78 and went for a drive in it afterwords![]()
Pura Vida
Surf to Surf Tomorrow
#2931
TEAM DHE/FAST 1976 KARMANN 8V FSP MK1 SILVER SCIROCCO 2X 08, 09. 10 & 12 regional champ.
TEAM DHE/FAST 1980 KARMANN 8V FSP MK1 RED SCIROCCO 04 & 07 regional champ.
1987 KARMANN 16V MK2 SILVER SCIROCCO
They are back--> http://www.parts4vws.com Need Wax?--> Mother's
#2932
Tonight I'll prep Victor for inspection in the morning. I just need to tidy up some wiring and run wires for the tach.
OMG I cant wait to get him on the road again!
#2933
Got it inspected for the first time in 2 years and had my buddy fix an exhaust leak that had come up recently..
Planning to replace a leaky waterneck and valve cover gasket tonight on the G60 and start driving here semi-regularly to work.
![]()
#2934
I tore off the old oil baffle in the oil pan
Unbolted the oil pump and
Installed a metal Windage tray with built in gasket ; )
Discovered my crank shaft has been balanced and machined
more awesomeness especially after finding out my head has been ported polished and machined
I put on a k&n diesel oil filter hp3001
And used full synthetic 20w50 castrol with added zinc.
Then added a little Rislone .5 quart for extra camshaft & lifter protection
Feels like a new engine, valve chatter and chains are a lot quieter, revs even harder, a little more power and response, No loss of power up hill or around curves uphill
I bought a 7$ down turn for open header for my tt dual downpipe which I'll install soon
Fixed vacuum leaks, replaced the NLA 16v cis-e boot with another nice one
![]()
#2935
Deal with it.
80 Scirocco|87 Scirocco 16v|74 Manta A|74 Land Cruiser|84 230CE|91 164L
=====>last.fm<=====|MusicGourmets.com
#2936
#2937
#2939
Went up to The Parts Place with a list of carp to get. Struck out on every item.![]()
Stopped at the shop on my way home, and replaced my fuel transfer pump.
Get home, and... it was so nice to not hear the main pump whining when I backed into the garage.
Yesterday, she was treated to:
- new bolts for the wheel center caps. Nice, SS shallow-head bolts from McMaster-Carr.
- a fabbed-up screen for the cabin air intake. Also sourced from MMC. I have a lot of extra....
Last edited by cuppie; 04-29-2012 at 06:33 PM.
- Cup
'88 Scirocco 16v, 'tastefully' modified.
things currently broken (Scirocco): 3
things currently broken (QSW): too many; but, slowly getting better
#2940
Upside down ABA/JH/MSnS build:http://forums.vwvortex.com/showthread.php?3322625
Frankenturbo: http://forums.vwvortex.com/zerothread?id=4102588
Magical Mystery Tour: http://forums.vwvortex.com/showthrea...l+Mystery+Tour
Cincy'11http://s1092.photobucket.com/albums/...b/Cincy%202011