First off head over to the Fabrication Forum for some cool stuff. Here is a teaser!
(BTW Google images changed their layout and I am having trouble getting bigger photos out of them! )
I am starting to clean things up, here is my system for grounds in the engine bay.
I will be using the same system for Switched power in the engine bay and under the dash.
This is a heat blanket from under a Ford truck's bed. The Exhaust runs close to the bottom of the bed so when trailer companies install a gooseneck hitch they remove these to put the hardware on. My local trailer shop gave me several. They happen to be sticky on the back side still!
Started working on the Mid-dump, however I ran out of cut-off wheels :/ Please excuse the mess it always gets crazy midproject
I think I found an okay place for my oil cooler, I am still on the fence about "flow" I out the inlet on top so the pump is not having to push through the cooler. I dunno if it really matters at all!
This will allow me to run my yellow inner lights and leave cooling room.
More coming during/after christmas!