Basically going to do a slight walk through of doing chain's on a W8 in pictures. Also when I say slight I mean not a step by step walk through.
Didn't take picture's right from the beginning with the front end still on but here we go anyways with it all removed.
After you disconnect all your wires and hose's (don't forget where anything goes) and disconnect any suspension part's necessary hook it all up to the table special tool #..... Now slowly drop it down after also unbolting the sub-frame, so it can all come down in one piece then stare in awww.
As you can tell by this point the wiring harness basically completely comes off of the engine minus a few connector's in the front. The exhaust manifolds come off, axles disconnected, and sub-frame dropped down on the table.
Modified by nevester at 1:14 AM 3-3-2010
Modified by nevester at 1:16 AM 3-3-2010
Modified by nevester at 1:26 AM 3-3-2010
Modified by nevester at 1:07 PM 3-3-2010
Modified by nevester at 10:29 PM 3-18-2010
Modified by nevester at 10:58 PM 3-18-2010