your R looks so good.
Its not perfect but then its part of the prototype front bumper lip so I'm not too fussed about that. One of the reasons I wanted to make the bumper lip was to create a flat surface to mount an air splitter to. Its just for show - car really isn't low enough for this to have a drastic effect. Its held on with self tapping screws so a 5 min job to take off. Covered it in 3m carbon vinyl to match the rest of the front end.
lol is his lip is so far past being custom cupra it shouldn't even have cupra in it
It's looking really good, truly jealous
2004 RS .:R32 WFC: Rota G-forces/ FK silverlines/ Unitronic 1+/ K&N Typhoon/ BMP Roof/ M3 Tails/ Hella Celis/ Flapper Mod_Res Delete SOLD
2008 Lightening Red STi
GTItraveler - As the flat bit is a prototype, its made of 6mm plywood! I painted it to make it waterproof to some extent and then wrapped it in the 3m Di-noc carbon vinyl!
duvinclunk - are you asking how I made the flat splitter or the other part to the bumper? There used to be a thread on that if so and will turn up eventually.
97audi4 - bumpers matched? Matched what?
Ya I love it. I would so do that to my BMP
ps what bumper/lip is that. I want to know
Last edited by gnatman; 06-17-2010 at 10:54 PM.
STEELERS, PENGUINS and PIRATES here we go BLACK 'n' GOLD
I love your front Lip, I think this summer I want to figure out how to make one my self