I'm running an aba alt with minimal mods. Just seconding that can be done to accomplish this on the cheap! also bump for a good seller.
#1
Here is a very hard to find bracket for the European Non-A/C serpentine setups..AKA ABF serp setups. This is just for the bracket itself, but you can use mk3 aba bracket and waterpump hardware to mount. The alternators are available new if you know where to look, or used on here. Alternatively you can mock up an ABA alt to fit this and have that clean accessory setup.
$50 shipped in the lower 48
The setup on an engine.
![]()
Last edited by IronTrap; 10-04-2012 at 09:43 AM.
#2
I'm running an aba alt with minimal mods. Just seconding that can be done to accomplish this on the cheap! also bump for a good seller.
#4
What else would be needed to run this on the ABA thats going into my gti?
#5
for an aba 8v
aba crank pulley
vr6 water pump pulley
aba or abf alternator
correct length belt which i have written down somewhere
#7
i think i already bought a vr wp pully from you!![]()
Last edited by -teknien-; 06-13-2011 at 10:28 PM.
#14
Can I run an power steering with this brake ?
ëuroBröke
Freedom-Industries.net
#17
Bump. I found a few more of these kicking around in my basement and threw a lick of Eastwood Alumablast on them so they look all fresh and clean! I also found a few OE springs for them as well. Add $10 for the OE spring.
![]()
Last edited by IronTrap; 10-04-2012 at 09:44 AM.
#18
These go for over $100 at the dealer and I picked up one of few left in the country. This is a GREAT deal.
Kudos to you sir.
#19
Dibs, send me your paypal info, need bracket and spring...