for a good turn a round
started work on my gas tank leak, siphoning out the gasoline was a pain until I searched vortex. Then i started on removing my brake calipers and then i found out that I didn't have an 8mm hex so I'm stuck until tomorrow. Hopefully adapters will be on by the 20th
I mean, to my knowlege 1000-2000 grit is just for the finish, not for prep, could be wrong though.
I would do 60, 220, 400, 600, 800 then paint. Then 800 wetsand between each layer and go into the 1000 and 2000 for the last layer for a good finish.
But i'm a body work virgin, just feel like i remember reading this somewhere, so take what i say with a grain of salt