Sold sold sold sold sold
I have a 1992 MK2 GTI with a supercharged VR6 swap. It's in overall good condition. Body is in really great shape, minus a few minor issues with some plastic trim pieces (mainly a cracked wheel arch fairing and loose front grill due to the motor setup). The interior is in good condition considering the age. The headliner is missing the cloth covering. The manual sun roof works fine and seals well. The e-brake cable for the right rear wheel lightly drags occasionally only if you set it very hard the prior time you parked it. All it takes to get it loose is to tap the ebrake actuator assembly on that wheel. I'm guessing some grease or WD 40 may fix it.
Motor is in very good condition. Runs very strong, sounds amazing, the only thing to bear in mind is that it does need a head gasket. Once that is fixed you'll have yourself a very nice stage 2 V1 supercharged 2.9L vr6 motor.
I am selling due to problems registering it in VA because of the engine swap. Should not be an issue in other states. I also prefer to sell rather than trade only because I need the cash to fix my airplane. A partial trade for a reliable daily driver plus cash would be acceptable for the right amount. Car is located just a couple of miles northwest of the Washington Dulles Airport.
Asking $4500 OBO. Trades accepted on a case by case basis, subject to car/bike condition and or cash amount.
Below is a list of the build/mods:
Started as a 92 slc vr6. Punched out to 2.9l
38k on the motor since it was built
111k on mk3 trans
TT Clutch kit and all hardware
Vortech V1 charger/8psi pulley with AMS bracket
cylinder head was fully rebuilt with I.E. guides, valves, seals and a resurface
matched ported upper intake to lower intake to the cylinder head
Kolbenschmidt 82 MM PISTON SET (OEM GERMAN)
new timing chains, guides
updated tensioner kit
CAT race valve springs
TT 262 Cams
new cam gears and bolts
new belt/idler pulley
new lifters, 050109309J; known as the light weight lifters
new main bearings
new rod bearings
new oil pump
new thrust bearings
mk4 head gasket
new intermediate shaft bearing set from FST
NGK bkre6e plugs
ABD Big Bore
TT 2.5 catback with Borla muffler
2.5 test pipe
Bosch 30lb injectors
C2 stage1 software
PS and AC delete
FK coilovers (11 months old)
like-new Borbet CA w/ like new 195-60 14
new brakes and rotors all around
new ebrake cables
new ball joints
new tie rods
Here is a walk around video from the previous owner, the wheels shown are NOT included.
More pics on request.