I love this. <3
Photobucket just earned itself some dislike here.
Finally got the photo bucket going
Found some rot
^These are still Pending install....
Got to working on the rear floor...
Ill finish up the last sheet once the rear slam panel is on...
Drive shaft flanges need too!
We All know what (RMR) parts look like......
Well after a few hours of work I changed that
I know wiring is everyones favorite
A small snap shot of HOW its done...
Position The Assembly Properly
^^^ THE PROPER TYCO TOOLING........
Seal Side PIC
Connection Side PIC
NOW feed all that into the following:
Plain Braided Sleeve
2 Port 3/4">X2 1/2 ports (DR-25 Seal Breakout)
2 port DR INTO Braided Sleeving
3M 6to1 2.5" heatshrink
Sealed "Through Wall" for the "BIG" wires (Starter-Fan-Alt-Lights-Ect)
AND a 38999 for the engine harness <Will have pics!!!
man you have been busy! looks great and i cant wait to see you beat the **** out of this thing! you sir are Proper!
I have been adjusting the driver input locations on the GTI for days now
FINALLY have the brake/clutch/steering/seating/shifting positioning sorted!!!
Adjusting the seating position and then matching the rest to ME and my liking
Quite the undertaking itself within this project
ALL of it feels 110% comfortable
Pics are in motion
Last edited by dub tek; 04-22-2012 at 09:15 AM.
very nice....very nice indeed!
Im sure it will go to the strip
It will do a local "auto cross" event day (VERY LOW KEY)
And a buddies folks own a private airport and i plan to do 0>150>0
You see it weekly............
They need a liquor bottle icon