selling some motor parts from the last 16v motor i had together in my car. heres the story though. i broke #3 wrist pin and obviously the piston and rod was damaged. so 1 new piston and 1 new rod was ordered. however i switched to 20v. this was pretty much the same setup that i ran when the car made 700 whp and went 9's. i will deff split them up or make a package deal for someone. i also have a good aba block and a 9a 16v lightened int shaft, drive gear and pulley that i can package together.
4 crower aba length(159mm) 20mm wist pin custom billet rods. 3 of these rods are used and 1 is brand new. all 3 of the used ones have brand new bushings and rod bolts and were all checked by crower. these rods retail for over $250 a piece. asking $850
4 je 9a 16v 20mm forged pistons. 83.5mm 11.3 comp ratio p/n 186234. 3 of these pistons were used for about 5 1/4 mile passes. 1 piston is brand new from je. i also have a set of spare 83.5mm wiseco rings that work on them. asking $400
lightweight int shaft, drive gear and pulley $60
Last edited by turbodub; 02-03-2013 at 07:59 AM.